SMC Networks LEC-W2-U Operation Manual page 4

The product is provided for use in manufacturing industries.
The product herein described is basically provided for peaceful use in manufacturing industries.
If considering using the product in other industries, consult SMC beforehand and exchange specifications or a
contract if necessary.
If anything is unclear, contact your nearest sales branch.
Limited warranty and Disclaimer/Compliance Requirements
The product used is subject to the following "Limited warranty and Disclaimer" and "Compliance
Requirements".
Read and accept them before using the product.
Limited warranty and Disclaimer
1. Grant of license
1. This Software is to be used in accordance with this Agreement non-exclusively for the limited purpose of
writing data to controllers for SMC electrical actuators.
2. This software can be installed and saved on a PC for the sole purpose specified in the preceding
paragraph.
2. Restrictions
1. This software is not to be copied, except as specified in Article 1-2.
2. This software license is not to be transferred or lent wholly or in part to a third party, either free of charge
or for payment.
3. Modification, translation, adaptation or reverse engineering of this software is not permitted.
3. Precautions
1. Read the "Safety Instructions", "Precautions", "Specific Product Precautions" and "Specifications"
described in the manual for the equipment when using any equipment controlled by this software.
2. This Software and the equipment controlled by it are subject to change without prior notice.
4. Exemption of liability
1. SMC cannot take any responsibility for any damage incurred by the use of the controller to which the
data is written by this Software.
2. SMC cannot take any responsibility for any damage incurred by the use of this software.
5. Termination
1. SMC has the full authority to terminate this agreement in the event of any terms and conditions have
been breached.
2. This software and any copies thereof must be destroyed when this agreement is terminated.
6. Rights of this Software
The copyright and any other rights of this Software are owned by SMC, and protected by Japanese
copyright laws and international treaty provisions.
Controller Setting Kit
Safety Instructions
Caution
-3-
No.JXC※-OMX0002