Flexispot Deskcise Pro V9B Installation Manual page 4

LCD display operation guide
Press the key button to turn on the LCD display. The following activity readings will appear on
the display: TMR (timer), SPD (speed), DIS (distance), CAL (calories), ODO (odometer),
RPM (revolutions per minute). The LCD display will turn off when pedaling stops for more than
4 minutes. To reactivate the LCD display, start pedaling again or press the key button.
Readout will be changed automatically one by one per 5 seconds
SCAN :
Time you exercised
TMR :
The speed when you exercise
SPD :
Distance you exercised
DIS :
CAL : Calorie you burned during your exercise
Total distance you exercise
ODO :
Speed of the wheel
RPM :
LCD display
Key button
-05-
Digital Display
Power Requirement:
2 x "AA" 1.5V batteries
Using the Bike
1. Magnetic resistance adjustment
The resistance control knob allows you to adjust the resistance level in increments from 1 to 8, with
level 8 offering the most resistance. To increase the resistance level, turn the resistance control
knob in the "+" direction. To reduce the resistance level, turn the knob in the "-" direction.
2. Adjusting the seat
Proper seat adjustment is essential to a comfortable ride when using the desk bike. If your leg is too
straight or your foot cannot touch the pedal, you will need to move the seat down. If your leg is bent
too much, you will need to move the seat up by lifting up your hip and pressing the handle bar. The
seat handle bar locate below the seat (see picture).
Seat
Resistance control knob
Seat handle bar
Pic ①
-06-