Origaudio PowR Stand Quick Start Manual

NOTE: Smartphone must already have a
wireless charging receiver installed and
wireless charging enabled to charge
wirelessly. Do not charge smartwatches with
this device.
HOW TO CHARGE
Plug the PowR Stand into a power source
using the provided micro USB cord. The PowR
Stand's indicator light will glow red indicating
it is in standby mode and ready to charge.
Place a wireless charging-compatible device
on the stand either horizontally and vertically.
IMPORTANT: Be sure to align the center of
your smartphone with the charging coil as
pictured in the diagram below to properly
activate the wireless charging. This may mean
adjusting the back panel up or down
accordingly to achieve a proper connection.The
indicator light will display pink to signal that
the device is successfully charging.
CHARGING
NOTE: If the indicator light flashes red, stop charging your
device and unplug the PowR Stand immediately. A flashing
red light indicates the PowR Stand is overheating or
experiencing voltage/current fluctuations. Wait for the
device to cool down and try again using a different outlet.
COIL
LOCATION
Indicator light:
• Red = Standby
• Purple = Charging
• Flashing Red = Stop charging/error
Adjust back panel up
or down to center
charging coil with
back of device
Flip bottom stand
down and place
device here