Garfield PARAGON 204 VACUUM & SPRAY Manual

Advertisement

Quick Links

VACUUM TREATMENT TIME VARIES, DIFFERENT SKIN TYPES REQUIRE DIFFERENT
TREATMENTS. PLEASE USE AT YOUR DISCRETION. WHEN THE SKIN IS THIN, DRY,
OR AGING, A LIGHT SUCTION IS RECOMMENDED. FOR OILY SKIN, IT IS
RECOMMENDED THAT THE VACUUM TREATMENT BE PERFORMED AFTER THE
DISINCRUSTATION TREATMENT WITH THE GALVANIC CURRENT.
WARNING:
BEFORE PLUGGING IN THE UNIT OR TURNING THE UNIT ON/OFF, BE SURE TO
RESET THE VOLUME CONTROL KNOB TO ITS MINIMUM SETTING. STARTING THE UNIT AT ITS
MAXIMUM SETTING MAY DAMAGE THE FUSE.
The vacuum system aids deep pore cleansing and is also referred to as the suction machine. The suction
removes out deeply embedded dirt, sedum and other impurities. Another benefit is a deep penetrating
massage, drawing blood to the surface of the skin. Note: the vacuum suction does not dislodge blackheads.
Included with this unit should be a pre-assembled complete handle, 6 glass ventricles, and 2 spray bottles.

VACUUM OPERATION

Connect the air tubing with the "yellow" adapter to the "yellow" connector on the machine. Also
A.
connect the tubing with the "green" adapter to the "green" connector.
B.
Select the appropriate ventouse and insert to the yellow adapter (a metal connector w/ a built in
filter).
C. Turn the green power switch to the ON position.
D. Turn the VACUUM ADJUSTMENT KNOB this knob clockwise MAX. (This knob can turn
approximately 1½-2 revolutions).
E.
The ventouse control hole should be covered when the ventouse is touching the skin and should be
uncovered when taken off the skin.
F.
After the vacuum treatment is complete, use the spray to lightly cover the face with a toner, and pat
dry with cotton pads or a clean towel. This will help remove any debris left on the skin and close the
pores.

SPRAY OPERATION

The spray bottle can be filled with distilled water or toner. The spray bottle is not recommended to be filled
with lotion; lotion is too thick and will cause the blockage of the very fine spray hole in the cap.
Connect the "green" adapter to the spray bottle.
A.
B.
Hold the bottle in an upright position.
C. Place your finger over the small hole at the top of the bottle.

MAINTENANCE

Attachments should be sanitized after each use.
A.
Wash glass ventouses and attachments thoroughly with soap and warm water.
B.
Soak the glass ventouses in alcohol for 5 minutes allowing them to sterilize.
C. Dry ventouses and store in sterilizer cabinet or autoclave.
PARAGON
204 VACUUM & SPRAY
ATTENTION Recommended for use by professional, state-licensed
estheticians.
Operator shall be responsible for and damages to
him/herself, the machine, and/or clients.
Before installing and/or using this unit, please carefully read these
instructions. Be sure to keep this available for later reference.
C A U T I O N
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PARAGON 204 VACUUM & SPRAY and is the answer not in the manual?

Questions and answers

Summary of Contents for Garfield PARAGON 204 VACUUM & SPRAY

  • Page 1 ® PARAGON 204 VACUUM & SPRAY ATTENTION Recommended for use by professional, state-licensed estheticians. Operator shall be responsible for and damages to him/herself, the machine, and/or clients. Before installing and/or using this unit, please carefully read these instructions. Be sure to keep this available for later reference. C A U T I O N VACUUM TREATMENT TIME VARIES, DIFFERENT SKIN TYPES REQUIRE DIFFERENT TREATMENTS.
  • Page 2 LA MIRADA, CA 90638  ® PARAGON is a trademark of Garfield International www.garfieldint.com ATTENTION For your protection in the event of theft or loss of this product, please fill in the information below for you own personal records. Model No _____________________________Serial No. _____________________________________ (Located on back or bottom side of unit.)

Table of Contents