Advertisement
™
Super-Vee
Operating Instructions
For 1-1/4" through 3" lines
(30mm – 75mm)
Pour français voir la page 7
Para ver el español vea la paginá 17
Y
our Super-Vee is designed to give you
years of trouble-free, profitable service.
However, no machine is better than its
operator. We therefore suggest you read
these instructions through carefully before
using your machine on the job. This will
enable you to operate the Super-Vee
more efficiently and more profitably.
Failure to follow these instructions may
cause personal injury to operator or
damage to equipment.
SAVE THESE INSTRUCTIONS!
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for General Super-Vee
Summary of Contents for General Super-Vee
- Page 1 (30mm – 75mm) Pour français voir la page 7 Para ver el español vea la paginá 17 our Super-Vee is designed to give you years of trouble-free, profitable service. However, no machine is better than its operator. We therefore suggest you read these instructions through carefully before using your machine on the job.
-
Page 2: Safety Instructions
Electric shock resulting in death personal injury. can occur if you plug this machine into an improperly wired outlet. If Call General’s customer service department at the ground wire is electrified, you 412-771-6300 if you have any questions. electrocuted just... -
Page 3: Personal Safety
Super-Vee™ 5. Do not abuse the cord. Never use the cord to 3. Disconnect the plug from the power source carry the tools or pull the plug from an outlet. before making any adjustments, changing Keep cord away from heat, oil, sharp edges or accessories, or storing the tool. -
Page 4: Variable Speed Switch
Super-Vee™ 2. The Skil drive unit used in the Super-Vee is 13. Only use this tool in the application for which double insulated, therefore it was designed. Follow the instructions on grounding wire. To reduce the risk of electric the proper use of the machine. Other uses or... - Page 5 1. Remove the cutter and screw from the cable, if 4. Slide the grip shield forward to release the cable. one is attached. Pull the Super-Vee back while holding the able in 2. Loosen the three screws that hold the front and place.
- Page 6 TO CLEAN OR REPLACE GRIPPERS clockwise. Note: The Hub Spindle, Hub, and If your Super-Vee is not gripping the cable properly, Drum Back remain as one unit; the Thrust Bearing the cable grippers may need to be cleaned or will come free.
Need help?
Do you have a question about the Super-Vee and is the answer not in the manual?
Questions and answers