Table Of Contents; Safety Precautions; Assembly / Setup - Texas A/S WR140 User Manual

GB - Table of Contents
Illustrations ................................................................... 2
Warning symbols .......................................................... 4
Safety precautions ....................................................... 8
Assembly / Setup ......................................................... 8
Change of brush ........................................................... 9
Operation ..................................................................... 9
Specifications ............................................................... 9
Warranty terms and conditions ..................................... 9
CE Certificate of conformity ........................................ 10
Spare parts
Spare part drawings for the specific product can be
on our website www.texas.dk
If you find the part numbers yourself, this will facilitate
more rapid service.
For purchase of spare parts, please contact your
dealer.
You will find a list of dealers on the Texas website.
Because of continued product development Texas A/S
reserves the right to improve the product without
obligation to improve already sold models.

Safety precautions

When using the product, the safety instructions must be
closely followed. Read this manual carefully before
starting the machine. Make sure that you know how to
stop and switch off the engine in case of accident. All
instructions regarding safety and maintenance of the
machine are for yours own safety.
The warnings, precautions and instructions given in this
manual, cannot cover all situations that the product can
be placed in. The user must therefore present common
sense and caution when using the product.
Safety in the work area

Only use the product in clean and well lit areas

Do not use the product in areas with explosive
danger or where there is flammable fluids, gas or
dust present.

The person that uses the machine is responsible to
other persons in the work area. Never use the
machine when others, especially children or
animals are near.

This product is an electric product. It is therefore
important, that it is never in contact with water or is
used in wet surroundings.
Use and maintenance of the product

A product must not be used for other work than as
described in this manual.

Only use original spare parts. Mounting of non-
approved parts may lead to increased risk and are
therefore not legal. Any liability is renounced for
accidents or other damage that has happened due
to the use of unauthorised parts.
found

Before using the machine the dealer or other
qualified person should instruct you in the use of
the machine.

Minors may not work the machine.

The machine may only be lent to people who know
how to work the machine. This manual should
follow the machine under all circumstances.

The product may only be used by persons who are
rested, well and fit. If the work is tiring, frequent
brakes should be made. Do not use the machine
under influence of alcohol.

Always check before start, that all bolts and nuts
are tigthened.

Always wear eye protection when using the
machine.

Keep children and other persons at a distance of at
least 5 metres from the work area.
Use original spare parts/accessories only
Identification of parts
Figure 1 WR140
1. Cable strain-relief clamp
2. On switch
3. Guard hood
4. Guide wheel
5. Additional handle
6. Safety lock-off
7. Rear handle
Figure 2 Parts in the box
1. Protection cover
2. Nylon brush and steel brush
3. Support wheel
4. Screws (4 pcs)
5. Nut
6. Tool
7. Pin
8. WR140

Assembly / Setup

Figure 3
3a) Insert part A in part B
3b) Fasten securly with a screw (3b-10).
Figure 4
4) Insert support wheel (4) in WR140 position A.
5) Place screen (3), as shown in picture 5. Fasten the
screen onto WR140 with 2 screws (10)
8