Page 1
WATERMIZER OPERATOR’S MANUAL Congratulations on your purchase of a new W & A WaterMizer. Be sure to read all the instructions in this manual before placing the machine in use. Safety precautions along with adjustments should be learned and also taught to anyone who operates the machine. Remember, an implement which is properly maintained, adjusted and safely operated saves time, labor and money.
Page 2
SAFETY SI NO LEE INGLES, PIDA AYUDA A AIGUIEN QUE SI LO LEA PARA QUE LE TRADUZCA LAS MEDIDAS DE SEGURIDAD. THIS SYMBOL MEANS -ATTENTION! -BECOME ALERT! -YOUR SAFETY IS INVOLVED! SIGNAL WORDS: WARNING: Indicates a potentially hazardous The signal words DANGER, WARNING and CAUTION are used with the safety situation that, if not avoided, could result in death or serious injury, and includes hazards...
Follow the Safety Requirements! GENERAL SAFETY REQUIREMENTS • Before operating your WaterMizer, thoroughly read and understand your operator’s manual. If you do not understand any portion of the operator’s manual, contact your dealer or W & A Manufacturing Company immediately.
TRANSPORTING • Comply with all federal, state, and local laws for implement transport on public roads. • Travel speed should be such that you maintain complete control and machine stability at all times. Watch for obstructions overhead and to side while transporting. •...
Tighten bolts holding Water Shank Assembly to tool bar. PERIODICALLY: Thoroughly clean and inspect your WaterMizer. Tighten all bolts as needed and check that all fasteners and keepers are in place and secure. Check water furrowers for wear and replace as required.
Page 6
Water Furrowers are designed to run flat. 5. Adjust tool bar gauge wheels to desired depth between 2” and 4” deep. Remember that the WaterMizer is designed to create furrows to efficiently move water and is not a plow.
Page 7
ASSEMBLY EXTREME CARE SHOULD BE USED DURING ASSEMBLY TO PREVENT INJURY TO HANDS, FINGERS AND FEET. 1. Mount the tool bar, gauge wheels and three point hitch assembly on the tractor three point hitch. 2. Attach Shank Assemblies (A) to tool bar at desired spacing. If planting on the flat, row widths may vary from field to field.
WARRANTY W & A Manufacturing Company warrants all products manufactured and sold by it to be free of defects in material and workmanship and to perform as represented, subject to the following conditions (A) Warranty applies only if installed and operated according to instructions. (B) Written authorization must be obtained prior to return of material for inspection.