Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Butts of Bawtry TBT0900
- Page 1 Battery Tester & Printer TBT0900 Instruction Manual...
-
Page 2: Work Area Safety
INSTRUCTIONS FOR USE INSTRUCTIONS FOR USE ISTRUZIONI PER L’USO OPERATION MANUAL AND INSTRUCTIONS FOR DIGITAL BATTERY TESTER, 12V, AND STARTING/CHARGING SYSTEM ANALYZER, 12-24V, MANUFACTURED BY: BETA UTENSILI S.P.A. Via A. Volta 18, 20845, Sovico (MB) ITALY Original documentation drawn up in ITALIAN. CAUTION Store the safety instructions with care and hand them over to the users. -
Page 3: Personnel Safety
INSTRUCTIONS FOR USE ISTRUZIONI PER L’USO • Do not cover the battery tester when using it. Allow adequate space for ventilation. contaminated environments increase the risk of electric shocks. PERSONNEL SAFETY drugs, alcohol, or medications. Always use the following personal protective equipment: •... -
Page 4: Technical Data
INSTRUCTIONS FOR USE ISTRUZIONI PER L’USO Additional personal protective equipment to wear according to the values found in the environmental hygiene/risk analysis survey if the values exceed the limits under current regulations. TECHNICAL DATA OPERATING VOLTAGE 9V ~ 36V DC (max) CAR OPERATING RANGE (CCA) 100A ÷... -
Page 5: Printing Test
INSTRUCTIONS FOR USE ISTRUZIONI PER L’USO PRINTING TEST Once the test has been completed, if the tester is equipped with a printer, test results can be printed by pressing the printer button after the test has been completed. If the tester is not equipped with a printer, follow the instructions contained in the last section. - Page 6 INSTRUCTIONS FOR USE ISTRUZIONI PER L’USO be displayed: Battery: Good: Battery: Recharge Battery: To replace: GROUNDING SYSTEM TEST - “GROUNDING TEST” Grounding Test...
- Page 7 INSTRUCTIONS FOR USE ISTRUZIONI PER L’USO START SYSTEM TEST - “STARTER TEST” 1. Clamp the black lead to the negative terminal of the motor vehicle battery. Clamp the red lead to the positive terminal of the motor vehicle battery. measured voltage. Result: OK Result: Abrupt Voltage Drop Result: Not Detected...
- Page 8 INSTRUCTIONS FOR USE ISTRUZIONI PER L’USO Result: Result: Result: State of charge is low! “ALTERNATOR TEST” WITH ELECTRIC LOADS ON rear demister. Do not use cyclic loads, such as air conditioning or windscreen wipers. will be displayed, along with the current measured reading. Result: Good Result: High Charge Result: Low Charge...
-
Page 9: Driver Installation
INSTRUCTIONS FOR USE ISTRUZIONI PER L’USO DIODE “RIPPLE” TEST determines ripple amplitude from the charging system to the battery). 4. One of the following results will be displayed, along with the current measured reading. Result: Ripple OK. Result: High Ripple DRIVER INSTALLATION IMPORTANT!! Before the drivers are installed, the tester should not be connected to the computer through the USB... -
Page 10: Maintenance
INSTRUCTIONS FOR USE ISTRUZIONI PER L’USO MAINTENANCE outer body, disconnect the device and clean with a soft cloth. Maintenance and repair jobs must be carried out by trained personnel. For such jobs, you can contact Beta Utensili S.P.A.’s repair centre. USER INFORMATION GEL BATTERIES A gel battery is a lead calcium battery with positive and negative plates immersed in a gelatinous... -
Page 11: Warranty
INSTRUCTIONS FOR USE ISTRUZIONI PER L’USO AGM FLAT PLATE BATTERIES These high-performance, maintenance-free batteries are ideal for deep cycling, high loading and working in partial states of charge. These batteries are suited to latest-generation Start & Stop systems. DISPOSAL The crossed-out wheelie bin symbol on the equipment or packaging means that the product should be collected separately from other types of urban waste at the end of its useful life.