Summary of Contents for Hongli A75
- Page 1 Model: A75 Drain Cleaning Machine Operation Manual WARNING! Read this Operator’s Manual carefully before using this tool. Failure to understand and follow the contents of this manual may result in electrical shock, fire and/or serious personal injury.
- Page 2 • When operating a tool outside, use an General Safety Information outdoor extension cord marked “W-A” or “W”. WARNING! Read understand instructions. Failure to follow all instructions These cords are rated for outdoor use and listed below may result in electric shock, fire, reduce the risk of electrical shock.
- Page 3 • Do not force tool. Use the correct tool for your Read this operator’s manual carefully before application. The correct tool will do the job better using the A75 Drain Cleaner. Failure to and safer at the rate for which it is designed. understand and follow the contents of this •...
- Page 4 Use of this safety equipment may prevent Weight......14KG serious injury. Dimensions • Only use the A75 to clean drain lines up to 4″ in Length ......200mm diameter. Follow instructions on the use of the Height ......440mm machine. Other uses or modifying the drain Width ......
- Page 5 4. Lubricate the Drain Cleaning Machine, if the machine while standing in water. • Flammable liquids, vapors or dust that may necessary, according Maintenance Instructions. ignite. 2. Position the Drain Cleaning Machine within 2′ 5. Use tools and accessories that are designed for your drain cleaner and meet the needs of of drain inlet.
- Page 6 2. Pull ten inches of cable from cable adapter operate if clutch handle is damaged or does not and slide into back of A75. function properly. Clutch is a safety feature 3. Lift plunger pin on cable adapter and depress...
- Page 7 FOR/OFF/REVERSE switch in FOR (forward) Do not allow tension to build up in the cable. This position. will happen if the cutting tool hits a snag and NOTE! The motor will start but cable will not stops turning, but the motor and cable continue rotate.
- Page 8 • Hand must be on the cable to control its 10. As excess cable is retrieved from line, twisting action when it hits an obstruction. hand-feed cable back into A75. • Must have access to FOR/OFF/REVERSE 11. Release clutch handle just prior to cable or switch.
- Page 9 Special Procedures periodically cleaned. Reverse Operation 1. Remove cable from the cable adapter. Cable Running machine reverse will cause is not attached to inside of drum. 2. Remove three 1/4″ screws holding tube and premature failure of cable. Use reverse only to free a tool or cable caught in an obstruction.
Need help?
Do you have a question about the A75 and is the answer not in the manual?
Questions and answers