HOLOPHANE Parkpak Installation And Maintenance Manual

AFTER INSTALLATION DELIVER THIS
MANUAL TO OWNER
IMPORTANT SAFETY INSTRUCTIONS
WARNING
-READ THESE INSTRUCTIONS
CAREFULLY BEFORE ATTEMPTING TO INSTALL OR
MAINTAIN THIS FIXTURE.
BY QUALIFIED PERSONNEL.
WARNING
-BE CERTAIN THAT ALL ELECTRICAL
POWER IS DISCONNECTED FROM THE FIXTURE
BEFORE INSTALLING OR MAINTAINING THE FIXTURE.
WARNING
-FOLLOW LAMP MANUFACTURER'S
OPERATING AND MAINTENANCE INSTRUCTIONS.
FAILURE TO FOLLOW THESE WARNINGS MAY
RESULT IN DEATH, INJURY OR SIGNIFICANT
PROPERTY DAMAGE.

1. INTRODUCTION

1.1 Product Description.

for use in wet locations and has been designed and tested to meet
UL standards.
- The Parkpak luminaire is used in both indoor and outdoor applica-
tions.
- The Parkpak is mounted in a variety of ways -- ceiling, horizontal,
vertical, pendant, flexible pendant, and quick install/through-wiring.
- Both square and asymmetric refractors provide excellent vertical
illumination.

1.2 Alternate Information Sources.

questions arise relative to the Parkpak that this document or your
supplier cannot answer, please refer them to :
Holophane
Field Service Department
P.O. Box 3004
Newark, OH 43058-3004
866-759-1577
Parkpak
WORK MUST BE DONE
The Parkpak luminaire is suitable
If additional
®

2. INSTALLATION

2.1 Tools and Materials Required.

Table 1. Installation Tools and Materials
Description
1/4 socket wrench
7/16 socket wrench
Flat screwdriver
Phillips screwdriver
Tamper resistant screwdriver
(if applicable)

2.1.1 General Mounting Information.

be surface mounted and connected to an outlet box, the luminaire
assembly must be connected to an outlet box marked for use in wet
locations and the mounting gasket provided must be used to create
a watertight seal between the luminaire assembly and the outlet box
or Latex caulk must be used to provide a watertight seal between
the luminaire assembly and the outlet box.

2.2 Horizontal Mount for Square Poles.

2.2.1

Remove the lens, door, and reflector. Remove the reflector
carefully in order to maintain the electrical connections between the
reflector and the housing. See Figure 1.

2.2.2

For the arm version, attach the arm to the pole and housing
to the arm using gaskets and fasteners as shown in Figure 2. For
the non-arm version, see Figure 3.

2.2.3

For supply connections, outside the housing, use wire rated
for at least 90 degree C. For supply connection inside the housing
use wire rated for at least 200 degree C. Connect supply leads to
marked leads on ballast or to the extra length leads provided with
the arm if applicable.
GR71
Figure 1
Installation and
Maintenance
Manual
Use
Fasteners
Fasteners
Fasteners
Fasteners
Tamper resistant fasteners
If this fixture is to
IM-83-C
GR636A