Advertisement
CERTIFICATION:
cULus WET
MOUNT CROSSBAR AND MAKE WIRE
CONNECTIONS
1
If there is an existing fixture remove it. Expose the supply
wires from the J-box. Mount the crossbar to the J-Box with the
supplied screws. Gently pull the supply wires through the hole
in the crossbar plate. Connect the black supply wire to the
black fixture wire. Secure with the supplied wire nuts. Connect
the white supply wire to the white fixture wire. Secure with the
supplied wire nuts. Attach the green J-Box wire around green
hexagonal head screw or connect it to the green supply
grounding wire of the fixture. Secure all wires with electrical
tape (not supplied).Tuck all wires carefully into the J-box.
MOUNT THE FIXTURE
2
Position the fixture plate over the crossbar.
Align the hole of the plate and secure with
the supplied screw knobs.
SECURE THE GLASS SHADE AND METAL
FRAME
3
Position the glass shade and metal frame over the fixture
plate. Align with the holes of the plate and secure with the
supplied screws.
*This fixture is wet location rated. In order to ensure that moisture
does not enter the outlet box and cause a short circuit, clear
caulking should be used to seal the space between the fixture
mounting bracket and the wall. Ensure that a space is left at the
bottom to allow for the escape of moisture. It is recommended
that Indoor/outdoor Silicon Sealant be used for this purpose. **
RESTORE THE ELECTRICITY AND
4
CHECK THE OPERATION OF YOUR NEW
ACCESS LIGHTING FIXTURE
2
20010LEDSWACDMG; 20010LEDSWADMG
NO.
If this fixture is to be removed or
replaced, please ensure that the
electricity is switched off and
that the fitting is cool before
touching it.
Advertisement
