Sony SLV-SF990G Operating Instructions Manual page 27

4
• If you connect the STB using the aerial
CURSOR
Press CURSOR M/m/</, to select RF
and press OK.
OK
Press CURSOR M/m/</, to highlight
PROGRAMME NO. and press OK. Enter
the appropriate number using CURSOR
M/m and press OK.
• If you connect the STB using the Scart
Press CURSOR M/m/</, to select
LINE-4 and press OK.
5
Press CURSOR M/m/</, to highlight
MENU
TUNER BRAND NO. and press OK.
Enter the appropriate number using the
programme number buttons. Refer to the
table on the next page. Press OK.
CURSOR
Press MENU to exit the menu.
OK
1 2 3
4 5 6
7 8 9
0
Notes
• If your VCR is connected to the STB by the aerial cable, enter the programme number of the
VCR corresponding to the channel where you have set up the STB output in step 4.
• It is recommended to connect your STB to the LINE-4 connector.
• For some STB, in order to avoid any conflict between the STB controller and the VCR
remote commander, be careful not to point the remote commander towards the STB and the
VCR at the same time.
• You cannot watch programmes from your STB on the TV while recording unless you record
a programme from your STB.
cable :
(EURO-AV) cable :
SET - TOP BOX
STB CONNECTION RF
TUNER BRAND NO . - - -
PROGRAMME NO . 0 6
RETURN
SELECT :
SET : OK
EXIT :
SET - TOP BOX
STB CONNECTION LINE4
TUNER BRAND NO. - - -
RETURN
SELECT :
SET : OK
EXIT :
SET - TOP BOX
RF
STB CONNECTION
TUNER BRAND NO . 1 2 3
PROGRAMME NO . 0 6
RETURN
SELECT :
SET : OK
EXIT :
continued
Setting the Set-Top Box
MENU
MENU
MENU
27