Advertisement
CHARGING INSTRUCTIONS
Follow this procedure before you use
VibraDent for the first time.
To reduce the risk of electric shock, this appli-
ance has a polarized plug (one blade is wider
than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to
install the proper outlet. Do not change the
plug in any way.
1. Plug the charger base into a 120-volt outlet.
Place VibraDent handle into the base and
allow it to charge for at least 16 hours
before using it for the first time.
2. The charger indicator light will show green
when VibraDent is correctly placed in the
charger base. The indicator will go out
when the toothbrush is removed from the
base.
3. The optimum voltage for charging is 120V.
4. To maintain the unit's full performance, it
should always be stored on the charging
base after use.
Note: Charge for at least 16 hours before
using the unit for the first time.
DuPONT
®
SOFT
BRISTLES
RUBBERIZED
HANDLE
ON/OFF
BUTTON
INDICATOR
LIGHT
TWO COLOR
CODED BRUSH
HEADS
CHARGING BASE
4
Figure 1
HOW TO USE VIBRADENT
1. Attach the brush head to the handle by positioning
the brush head at a 90
handle. Turn the brush head counter clockwise one
quarter turn, so the bristles are facing the same
direction as the ON/OFF button. (See Fig.1)
2. Before brushing, rinse your mouth thoroughly and
wet the brush head to moisten, then apply tooth
paste.
3. To avoid splashing, guide the brush head to your
teeth before switching VibraDent on. Place the
brush in a slanted position, 45
line.
Outside teeth
4. Press the "ON" button to activate the unit.
5. Gently guide the brush head from tooth to tooth,
spending a few seconds on the surface of each
tooth.
6. Brush the gumlines as well as the teeth, starting
with the outside teeth and gums, followed by the
insides and finishing with the chewing surfaces.
Inside teeth
7. Do not press too hard or scrub with VibraDent.
Allow VibraDent to do the work.
8. When finished, press the off button.
9. Rinse mouth thoroughly with water.
10. Brush heads should be replaced every 2-3 months
to ensure optimal performance.
HoMedics replacement heads (RH-V) for this
Chewing surface
model are available at your local retailer or check
www.homedics.com for a list of retailers that offer
these replacement heads.
o
angle to the left of the
o
towards the gum
5
Advertisement
