Getting Ready To Sew Connecting The Power Supply; Using The Foot Control; Before Using Your Sewing Machine; Operating Instructions - Janome C30 Instruction Book

q
t
i
e
w
r
u
y
GETTING READY TO SEW
Connecting the Power Supply

Using the foot control

Turn off the power switch.
Insert the pin connector into the jack.
Insert the machine plug into the power inlet.
Insert the power supply plug into the wall outlet.
Turn on the power switch.
q Power switch
w Pin connector
e Jack
r Machine plug
t Power inlet
y Power supply plug
u Wall outlet
i Foot control
WARNING:
While in operation, always keep your eyes on the
sewing area and do not touch any moving parts such
as the thread take-up lever, handwheel or needle.
Always turn off the power switch and unplug from the
wall outlet:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control.

Before Using Your Sewing Machine

Before using your sewing machine for the first time,
place a scrap of fabric under the presser foot and run the
machine without thread for a few minutes. Wipe away any
oil which may appear.

Operating Instructions:

The symbol "O" on the switch indicates the "off" position
of the switch.
Foot control model 4C-339-JM is used with this sewing
machine.
For the U.S.A and Canada only:
For appliances with a polarized plug (one blade wider
than the other): To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only one way.
If it still does not fit, contact a qualified electrician to
install the proper outlet. Do not modify the plug in any
way.
5