Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Vacuworx RC 10
Summary of Contents for Vacuworx RC 10
- Page 1 VISIT VACUWORX.COM TO DOWNLOAD COMPLETE OPERATION MANUAL...
- Page 2 job site preparation RC SERIES JOB SITE PREPARATION Make sure the hoses from the excavator are connected with the flow in the correct direction. Connect the hoses to the flow control valves. Do no TRANSPORT THE LIFTER over-tighten the fittings. Over-tightening will cause Always turn the fuel shutoff valve to the OFF position when damage to the fittings.
-
Page 3: Operation
(which is the responsibility of the owner or contractor). Contact your Vacuworx representative for additional training information. Before operating this equipment, read the entire Operator’s Manual and become familiar with the operating controls and... -
Page 4: Before Starting The Unit
Turn the key (Fig. 1-3, 1) to the right to the START position. Once the engine starts, release the key. Fig. 1-4 NOTE: When working in extreme altitudes, please contact Vacuworx Technical Service +1-918-259-3051 for additional information. The gauge on the vacuum pad always reads zero until Fig. 1-3 vacuum has been activated. - Page 5 RC SERIES operation WIRELESS REMOTE TRANSMITTER NOTICE OPERATION (PRODUCTION) For safety purposes, there will be approximately a three-second delay on the release function. TURNING ON THE REMOTE The wireless remote transmitter should be located in a TURNING OFF THE LIFTER convenient place inside the cab.
- Page 6 operation RC SERIES LIFT A LOAD WIRELESS REMOTE TRANSMITTER OPERATION (LEGACY) Do not activate vacuum when pad is not on material to be lifted. If pad is not properly placed on material when vacuum The wireless remote transmitter should be located in a is activated, the vacuum in the reservoir might be lost.
-
Page 7: Shutdown And Storage
RC SERIES operation Fig. 1-8 When load is at the designated spot, slowly lower the load. Never release the vacuum when the load is off the ground. When in the correct position, press and hold the top left and right buttons (Legacy) or top 2 circle shaped buttons (Production) to release the load. - Page 8 P T11 0 2 -00 4 0 9 /1 8 C OP YR IGH T © 20 1 8 VAC UWO RX ®...