Summary of Contents for Well Vision
- Page 1 Installation and Operating Manual Head Up Display Model: Vision Thank you for choosing WELL. Please read carefully the following instructions and keep them within reach. Preorder NO.: HUD-5-VISION-WL...
- Page 2 Functions 1.Alarm Icon: High water temperature / Low voltage alarm / shift reminder / over speed alarm / Fatigue driving Engine Error 2.Multi-functions display: RPM / Voltage / driving distance /clock / water temperature / fuel consumption 3.Light sensor:HUD can automatically adjust the brightness according to the environment 4.Mileage unit:TRIP means the driving distance from engine start to off 5.Fuel consumption unit: unit of Average fuel consumption per hundred kilometers / instantaneous fuel consumption =AVG...
- Page 3 1.find out the OBD interface in vehicle 2.put the HUD on the dashboard 3.hide the OBD cable according to the seam HUD recommendation place Entering the menu setting mode Note:When the HUD datas is different with dashboard datas,please adjust the HUD menu.
- Page 4 1.Please confirm that the HUD has been connected to the car OBD2 interface well and HUD is normally working. 2.Find out the HUD setting wave button 3.Long press in the button to enter into the setting mode, and do it again to save & exit...
- Page 5 When start the engine, HUD will display, then the user can use the quick setup way to adjust the HUD Switch the multi functions Short Push up the button, will only display speed. Short Push in the button can switch the functions...
- Page 6 Quick to do factory reset When HUD is off, long push in the setting button, and at the same time, plug the USB port to the HUD device Turn on / off buzzer: when HUD in normal display, push down the button for 5 seconds to turn off the buzzer, do it again to turn on buzzer Menu setting Mode Explanation How to enter into the menu mode?
- Page 7 When RPM over 5000, HUD will give Shift alarm, up or down the wave button to reminder adjust, adjust range(1000-7500) Four-stage 0=turn off the four-stage alarm 1 = turn on the four-stage alarm speed alarm (60KM/H,80KM/H,100KM/H,120KM/H),s peed alarm shows up when it reaches to above four speed Single-stage The default over speed alarm is 150...
- Page 8 Troubleshooting 1.The screen without any display,and no power Start the car engine;check if the OBD cable line is tight;please pull down the OBD cables more times to ensure;check if product power switch turns on. If still no display ,please change another car to test, analyze whether the car OBD diagnostic interface is good, if it is not good,please repair it and try again.
- Page 9 HUD display three kinds of fuel consumption a.Idle mode: HUD display Instantaneous fuel consumption per hour (L/H), it means HUD can figure out how much oil the car will consumed when start engine after one hour b. Driving mode: HUD display Instantaneous fuel consumption of 100KM c.
- Page 10 Technical Parameters 1.Environment temperature: - 40 0C— +80 0C Barometric press: 86-106KPa Relative humidity:10%-95% Environment voice:<=60dB 2.Work voltage:11V~18Vdc(12Vdc/200mA) 3.Sleep current:<=30mA 4.Product size: fold 135X68X30 mm, full size:135x68x56mm 5.Projector image size:90x20mm 6.Display way: projector 7.Display channel :LED Display 8.Reflector transmittance: 96% 9.