NI VXI-EFD Installation Manual

NATIONAL
INSTRUMENTS
The Software is the Instrument
This installation guide contains instructions for installing and configuring the VXIpc-EFD
external floppy drive for use with the VXIpc-486 Model 200 Series and Model 500 Series
embedded computers.

Introduction

The VXIpc-EFD is a 3.5 inch, 1.44 MB floppy drive you can use to transfer files between the
VXIpc-486 and other PC compatibles. The VXIpc-EFD is compatible with all VXIpc-486/1
models and with VXIpc-486/2 models that do not have an internal disk drive. It is also equally
compatible with VXIpc-386 models.
The VXIpc-EFD kit consists of an external floppy drive with an attached cable, part number
776404-01, and this document.

Connection

Connect the VXIpc-EFD to the VXIpc-486 as follows:
1. Power-down the VXIpc-486 module.
2. The VXIpc-EFD cable connects to the connector labeled DISK DRIVE on the front panel of
the VXIpc-486 module as shown in Figure 1. Check that there are no bent pins on the
VXIpc-EFD connector. Carefully straighten any bent pins with needle-nosed pliers.
3. Connect the cable to the connector and tighten the jackscrews until securely seated.
_____________________________
VXIpc™-486 is a trademark of National Instruments Corporation. Product and company names are trademarks or
trade names of their respective companies.
320334-01 © Copyright 1991, 1994 National Instruments Corporation. All rights reserved.
®
®
VXIpc-EFD
Installation Guide
Installation Guide
May 1994