Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Packard Bell Compasseo 450
Summary of Contents for Packard Bell Compasseo 450
- Page 1 Packard Bell Compasseo 450/460/480 Disassembly Manual...
-
Page 2: Table Of Contents
For More Information..........................2 Technician Notes............................2 Disassembly ............................. 2 Reassembly .............................. 2 Required Tools ............................2 Casing..............................3 Battery..............................4 Main Board.............................. 5 GPS Board............................... 6 Speaker..............................7 Touch Screen............................7 Notice ..............................8 Packard Bell Compasseo 450/460/480 Disassembly Manual... -
Page 3: About This Guide
This guide contains systematic disassembly instructions for the Packard Bell Compasseo 450/460/480. The instructions are illustrated where necessary with images of the part that is being removed or disassembled. Packard Bell B.V. reserves the right to make changes to the Compasseo 450/460/480 without notice. For More Information For more information about the Packard Bell Compasseo 450/460/480, visit Packard Bell‘s support web site... -
Page 4: Casing
Note: When separating the back cover from the device, keep in mind not to tear the label covering the headphone, the TMC (optional), and the USB connectors on one side of the GPS device. Packard Bell Compasseo 450/460/480 Disassembly Manual... -
Page 5: Battery
1. Disconnect the battery cable from the main board. Fig. Removing the battery. 2. Pull the battery until it comes loose and take it out of the device as shown in Fig. Note: The battery is glued to the main board. Packard Bell Compasseo 450/460/480 Disassembly Manual... -
Page 6: Main Board
3. Gently lift one side of the main board out of the device. Fig. Removing the GPS board. Note: You cannot completely separate the main board from the device, because it is still attached to the touch screen. Packard Bell Compasseo 450/460/480 Disassembly Manual... -
Page 7: Gps Board
To remove the GPS board, perform the following steps: Remove the tape securing the GPS board to the back of the touch screen. Fig. Removing the GPS board. Slide the GPS board upwards and take it out of the holder (see Fig. Packard Bell Compasseo 450/460/480 Disassembly Manual... -
Page 8: Speaker
1. Gently push the touch screen from the inside out (bottom side first) to separate it from the front cover. Note: You may have to bend the front cover a bit in order to release the touch screen. Packard Bell Compasseo 450/460/480 Disassembly Manual... -
Page 9: Notice
This guide contains information protected by copyright. No part of this guide may be photocopied or reproduced in any form or by any means without prior written consent from Packard Bell B.V. PACKARD BELL B.V. SHALL NOT BE HELD LIABLE FOR TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN;...