Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Take a Swing Manuals
  4. Baby Swing
  5. HOMESTAND II
  6. Owner's manual

Take a Swing HOMESTAND II Owner's Manual

Swing frame system
Hide thumbs

Advertisement

Quick Links

Download this manual
Homestand II
Swing Frame System
Owners Manual
Manufactured by

Advertisement

loading
Need help?

Need help?

Do you have a question about the HOMESTAND II and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Take a Swing HOMESTAND II

  • Page 1 Homestand II Swing Frame System Owners Manual Manufactured by...
  • Page 2 Yoke (top piece) Swivel Leg top Stop bolt Catch bolt Leg bottom Rope Rope swing swing hanger hanger Attaching Snap Pins Quick clip...
  • Page 3 Take a Swing Take a Swing Take a Swing sincerely wish that the Homestand II will meet all your needs in a swing stand. Please, do not hesitate to contact us with comments, questions, or thoughts for new swings or accessories. They are always welcome.

  • Page 4: Safety Instructions

    Please follow these common sense safety warnings and do not use the Homestand II for anything other than its in- tended therapeutic purpose. Check for damaged parts and make sure that all the nuts, bolts, and other fasteners are in place and secure. Check for rope damage.
  • Page 5 HOMESTAND II SWING STAND SYSTEM PARTS LIST Quantity Description Yoke (the bent welded piece) Leg tops (has the sleeve that fits into the yoke) inch material Leg bottoms (with the black poly-urethane feet) inch material Special bronze bolt sets (4 sets are attached to the legs)
  • Page 6 The Take a Swing Take a Swing Take a Swing Take a Swing Swivel can be attached to any eyebolt. Simply remove the key ring to free up the clevis pin at the top of the swivel. Bring the swivel to the eye bolt and replace the pin with the appropriate Nylon washers.

  • Page 7: Setup Instructions

    SET-UP INSTRUCTIONS These Assemble the legs holes Stop bolt are for hole The leg top has 2 sets of 2 Catch holes for the two stand heights. Foot bolt hole One hole is the stop and height the other is the catch. Bronze bolt leg stops are pre-installed for the 7 1/2 height.
  • Page 8 Here you are holding the leg top with the sleeve on the floor. See the Mylar tape? Now insert the leg bottom, twist a leg so the holes line up and secure the with a bronze bolt set. Or, you can lay both legs on the floor or a large table to assemble them.
  • Page 9 Lay out the 4 legs on the floor about where it will be set up. Leaving 8 or 9 feet as shown below Using the Snap Pins to attach the legs to the yoke Insert the pin through the yoke and leg Pic A You can make the snap pins...
  • Page 10 First , lift up the yoke and a leg to about the height as shown below and slip the sleeve (the top of the leg) into the yoke. You will need to line them up as best you can by moving the leg or yoke until the leg slides all the way in.
  • Page 11 You may need a stool or some help with this next procedure. Lift up the unit and the third leg if you are alone or have some one hand it to you. Now you have to hold it up and slip in the third leg at the same time.
  • Page 12 As you can see, the Homestand II will stand with 3 legs. But just barely. Quickly grab the 4th leg, attach and secure. there you have it. Finish reading the manual, and you will be swinging in no time.
  • Page 13 To attach swings the rope needs a loop at the swing ends or chain. Take a Swing swings have metal hook attached to the ends of its rope. Push the loop into the connector clip as shown in the picture below.
  • Page 14 The vigorous swinging of an older heavy person will need a sturdier frame. Another heavy person may need only slight motion and can do well with either a Homestand II or HPSI frame For instance, here is a picture of 3 guys all over 200 lbs., about 650 Lbs total on the Homestand II.
  • Page 15 (please see below) Three year Limited Warranty on all swing frames Take a Swing frames are guaranteed against defects in materials and workmanship for three (3) full year from date of shipment. Any such defect will be repaired or the product replaced, at our option. You must contact us for a return authorization before sending us any equipment for repair.
  • Page 16 30 days of return authorization. If you receive defective or wrong merchandise as a result of a Take a Swing error, we will pay for the return shipping expense. Also, please include your...