Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for ML Knightsbridge HBL Series
- Page 1 INSTALLATION & MAINTENANCE MANUAL HBL series 230 V 50Hz...
- Page 2 / HBL240 GENERAL INSTRUCTIONS These instructions should be read carefully and retained after installation by the end user for future reference and maintenance. These instructions should be used to aid installation of the following products: f this luminaire should only be carried out by a qualified electrician or competent person HBL100 / HBL150 / HBL200 / HBL240 g and current IEE Wiring Regulations (BS7671) e mains prior to installation/maintenance SAFETY...
- Page 3 Bracket mounting mounting • Using the bracket as a template, mark the location of the fixing holes, drill 2 x 10mm holes Using the bracket as a template, mark the location of the fixing holes, drill 2x 10mm holes ensuring not to ensuring not to infringe with any joists, gas or water pipes or electrical cables infringe with any joists, gas or water pipes or electrical cables • Using a hammer, tap the expansion bolts into the 10mm fixing holes (see Fig 2) Using a hammer, tap the expansion bolts into the 10mm fixing holes (see Fig 2) •...
- Page 4 Fig 4 • Position the driver housing into the bracket ensuring all Allen screw holes are correctly aligned and fasten down the 4 Allen screws (see Fig 5) Position the driver housing into the bracket ensuring all Allen screw holes are correctly aligned and fasten down • the 4 Allen screws (see Fig 5) Fasten down Allen screws Lift the fitting up to the expansion bolts and slide into the bracket (see Fig 6) Fig 5 Fig 5 the fitting up to the expansion bolts and slide into the bracket (see Fig 6) • Lift the fitting up to the expansion bolts and slide into the bracket (see Fig 6) Fig 6 Fig 6 Tighten the 2 expansion bolts to secure the luminaire to the surface...
- Page 5 To wire the luminaire with a 1-10V dimmer (see Fig 8) To wire the luminaire with a 1-10V dimmer (see Fig 8) Neutral - blue Earth – green/yellow Blue: Dim + Live - brown White: Dim - Fig 8 To wire the luminaire with HBLS (see Fig 9) Fig 8 To wire the luminaire with HBLS (see Fig 9) Earth – green/yellow Live - brown Neutral - blue Neutral - blue Live - brown White: Dim - Black Switched live - yellow Blue: Dim + Attach the microwave sensor mounting bracket using the 5x screws provided Fig 9...
- Page 6 INSTALLATION Detection area Detection area can be adjusted from a maximum range of 15 meters down to 7 meters by observing the below settings Detection Area 100% Hold time Hold time refers to the time that the luminaire will remain at 100% brightness after no motion is detected HOLD TIME 5sec...
- Page 7 Standby dimming level This setting refers to the light level you require once “hold time” has elapsed STANDBY DIMMING LEVEL Daylight sensor This setting is to set the ambient light level you would require the luminaire to operate in, selecting “DISABLE”...
- Page 8 If this product should fail within its warranty period it should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are not affected.
Need help?
Do you have a question about the Knightsbridge HBL Series and is the answer not in the manual?
Questions and answers