EDISON Professional EN-1600 Operation Manual

EDISON Professional EN-1600 Operation Manual

Advertisement

OPERATIONS MANUAL FOR EDISON PROFESSIONAL 
EN-1600

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EN-1600 and is the answer not in the manual?

Questions and answers

alfred Pruneau pruneau
January 21, 2025

how do I cancel the bluetooth ? s0 I can use my new phones bluetooth

1 comments:
Mr. Anderson
May 14, 2025

To cancel Bluetooth on the EDISON EN-1600, short press the MP3 module button to switch from Bluetooth to another mode such as SD, USB, or FM radio.

This answer is automatically generated

Summary of Contents for EDISON Professional EN-1600

  • Page 1 OPERATIONS MANUAL FOR EDISON PROFESSIONAL  EN-1600...
  • Page 2 OPERATIONS MANUAL FOR EDISON PROFESSIONAL  Introduction:  Congratulations on your purchase of an EN-1600 powered loudspeaker, engineered and manufactured by Britelite Enterprises. The EN-1600 includes a high-output compression driver, and 15” woofer to produce an even, smooth studio quality sound in a sound reinforcement speaker. Our design goal was to build a speaker with accurate playback, smooth dispersion of mid and high frequencies and an ergonomic design for easy transport and setup.
  • Page 3 OPERATIONS MANUAL FOR EDISON PROFESSIONAL     ...
  • Page 4 OPERATIONS MANUAL FOR EDISON PROFESSIONAL  1. MP3 module: Short press: Bluetooth, SD, USB, FM radio switch Short press: REPEAT; Long press: EQ setting Short press: Last and next; Long press:Volume – or + 2. Line/MP3 input volume: Control the Volume of line/MP3 input 3. Master volume : Control the Volume of speaker . 4.
  • Page 5: Troubleshooting

    15. Power on/off 16. LED lighting on/off Placement Tips -Avoid placing loudspeakers in the corners of a room. This increases the low-frequency output and can cause the sound to be muddy and indistinct. -Avoid placing loudspeakers against a wall. This, too, increases the low frequency output, though not as much as corner placement.
  • Page 6 OPERATIONS MANUAL FOR EDISON PROFESSIONAL    cables, balanced ¼” jacks; RCA cables are not balanced) o Whenever possible, plug all the audio equipment’s power cords into the same outlet. o The hum may appear when using an unbalanced source (CD player, iPod, etc.). Use can use an RCA to XLR adapter to turn an unbalanced cable to a balanced cable. o If the hum persists, try removing components one at a time from the back of the mixer and check each for hum.
  • Page 7 Your active speakers will provide many years of reliable service if you follow these guidelines: Avoid exposing the loudspeaker to moisture. If they are set up outdoors, be sure they are under cover if you expect rain Avoid exposure to extreme cold. If you must operate loudspeakers in a cold environment, warm up the voice coils slowly by sending a low-level signal through them for about 15 minutes prior to high-power operation.
  • Page 8 FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. FCC Warning  This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Table of Contents

Save PDF