Advertisement
Double press the power switch button at any
mode , will activate turbo output,
which is up to 53000 lumens, double
press the power switch button again will
activate strobe, slightly press the power switch button to exit.
4. Side lights mode
With the flashlight off, press and
hold
the switch button for one second to turn on the side
lights.With the side lights on,
slightly
press
the button to change output levels,
high-medium-low. Press and hold it for one second again to quit side lights mode.
5. Low battery warning
With the flashlight on,when the battery voltage is lower than 11.8V,the red indicator
will turn on. When the battery voltage is lower than 11V,the red indicator will flash
constantly to remind users to replace the battery or charge it.
6.Intelligent thermal control
While using the high output mode, the flashlight will generate a lot of heat. When
the
flashlight
body internal temperature
reaches 55 degrees Celsius,
it will
automatically
reduce
the
brightness
to 15000lm
in
order
to
ensure
safe,
comfortable use and prevent discomfort from overheating.
7.Memory function
The flashlight will remember the brightness that it was previously set at. When you turn the
flashlight on again, it remembers how bright it was before being turned off. (Special modes
without memory)
8.Lock and unlock
With the flashlight off, press the switch button 3times, the red indicator will flash
twice to indicate the flashlight is locked. Press the switch button 3 times again,the
green indicator will flash twice to indicate it unlocked,and can work normally.
Built-in Cooling Fan
1. When the MS12 is in high output mode, the cooling fan automatically turns on
once the flashlights body reaches 55 degrees C.
2. With the flashlight off, quickly press the switch button 4 times to activate the
cooling fan in order to cool off the flashlight.
3. When under 15,000 lumens of output, the cooling fan will not turn on.
9. Charging
The product comes with intelligent charging function.Plug in one of the adapters as the picture
shows into an electrical outlet(24V/2A),and plug in the other adapter into the indoor socket. It will
take about 4 hours 38mins to fully charge
As shown in Picture 1, the contact points of the positive and negative poles of the flashlight body
are all in the same plane, and the plane must not be inverted on the conductor, otherwise the
circuit board will be short-circuited.
Maintenance
Every 6 months, the inner threads should be wiped with a clean cloth followed by a thin coating of
silicon-based lubricant.
Advertisement
