Summary of Contents for Sonotechnique CPD16
- Page 1 CPD16 MIDI/GPIO INTERFACE INSTALLATION MANUAL STANDARD EDITION Document # CPD16 manual V1.1.DOC November 2005 Tel: 514 332 6868 Fax: 514 332 5537 www.sonotechnique.ca...
- Page 2 The CPU unit should be installed in a proper ventilated Rack. Default to proper ventilation may result in premature circuit degradation. • Rear panel connector layout sonotechnique CPD16 Audio I/O GPI Outputs GPI Inputs Serial 2/Midi Serial 1 • Front View sonotechnique CPD16 33 34 35 36 CPD16, installation guide...
- Page 3 Audio 2 monitor Input Left (-) From Audio 2 source Left (-) Analog Ground Audio 2 monitor Input Right (+) From Audio 2 source Right (+) Audio 2 monitor Input Right (-) From Audio 2 source Right (-) Analog Ground Not connected CPD16, installation guide...
- Page 4 Dgnd GPI Output 12 Open Collector 100mA / 30V 5 Volts Fused at 500mA GPI Output 13 Open Collector 100mA / 30V Open Collector 1 Open Collector 2 Equivalent Circuit Open Collector 15 Open Collector 16 DGnd CPD16, installation guide...
- Page 5 Opto-isolator 1K series 5 Volts Min / 30mA max 5 Volts Fused at 500mA GPI Input 13 Opto-isolator 1K series 5 Volts Min / 30mA max Opto-Isolator common 1-8 Opto-Isolator 1 Opto-Isolator 2 Equivalent Circuit Opto-Isolator 7 Opto-Isolator 8 CPD16, installation guide...
- Page 6 Equivalent to Midi output, Din 5, pin 2 • Serial 1 / RS232. D9 Female chassis connector pin assignment PIN # Description Notes No connection No connection TX RS 232 No connection TX RS 232 No connection No connection No connection Digital Ground CPD16, installation guide...
- Page 7 Mode 0 Normal mode. In this mode, the CPD16 will respond to GP Inputs and midi messages as configured in the dumped file. Led A & B will display the status of the Ctl Room A & B respectively. Lighted = Muted Led C to H are not used and will be off.
Need help?
Do you have a question about the CPD16 and is the answer not in the manual?
Questions and answers