Audio enhancement BEAM Quick Start Manual

BEAM LED Status Indicators visible through the front grille

Microphone 1 LED

Mounting screws

TONE CONTROLS

Low—controls boost or cut of bass frequencies

Mid—controls boost or cut of vocal frequencies

High—controls boost or cut of treble frequencies

The VOLUME knob controls the level of Media sources

(computer, monitor, DVD player, etc.) connected via 3.5

mm audio cable or TOSLINK optical cable.

It has no e ect on the Microphone or Bluetooth levels.

The UP and DOWN buttons on the microphone, when

"LINE" has been SELECTED, will also control the level of

the MEDIA sources.

Remember, the output level from your source needs to

be turned on and at an appropriate level.

www.AudioEnhancement.com • 800.383.9362

BEAM Front

Microphone 2 LED

BEAM Rear

VOLUME

BEAM

Quick Start Guide

Note: Green Power LED

Green Power LED

must be ON indicating

the BEAM is plugged

into AC outlet

XD Microphone LINK LED

• XD Teacher Microphone Included

• Mic360 Optional

Table of Contents

Do you have a question about the BEAM and is the answer not in the manual?

Page 1 BEAM Quick Start Guide BEAM Front Note: Green Power LED Green Power LED BEAM LED Status Indicators visible through the front grille must be ON indicating the BEAM is plugged into AC outlet Microphone 1 LED Microphone 2 LED XD Microphone LINK LED...
Page 2 This is typically a small battery-powered FM transmitter and can be plugged directly into the Assistive Listening Output. A 3.5 mm to 3.5 mm cable is required to connect between the BEAM and Plug in student FM device here student’s device. The Assistive Listening Output allows the level to be optimized for the student’s device.
Page 3 Step 3—The charger indicator light will (LINE) Level Adjustment remain on once fully charged. Selecting the LINE audio source will control the volume of audio from devices that are connected to the BEAM via 3.5 mm audio cable or TOSLINK optical cable. www.AudioEnhancement.com • 800.383.9362...
Page 4 Typically this is the volume control on your phone. Press and hold the PWR/LINK button and To pair a new device to the BEAM, rst disconnect the paired TALK pushbuttons together on the device, then follow the directions above for the new device.