5: Adding To Z-Wave Network; Adding Manually - FIBARO WALLI FGWREU-111 Operating Manual

5: Adding to Z-Wave network
Adding (Inclusion) – Z-Wave device learning mode, allowing to add
the device to existing Z-Wave network.
5.1: Adding manually
To add the device to the Z-Wave network manually:
1. Power the device.
2. Set the main controller in (Security/non-Security Mode) add mode
(see the controller's manual).
3. Quickly, three times click one of the buttons.
4. If you are adding in Security S2 Authenticated, scan the DSK QR
code or input the underlined part of the DSK (label on the bottom
of the box).
5. LED will start blinking yellow, wait for the adding process to end.
6. Adding result will be confirmed by the Z-Wave controller's message
and the LED frame:
Green – successful (non-secure, S0, S2 non-authenticated),
•
• Magenta – successful (Security S2 Authenticated),
Red – not successful.
•
aDDIng to Z-Wave netWork
11