Table of Contents
Advertisement
Dugan Model E-2 User Guide
Naming Units and Channels
Connected units are displayed in the top pane in alphabetical order. Use names with
number prefixes if you wish to display them in your own order.
To name a unit and its channels:
1. Select a unit in the top pane.
2. Select the yellow text in the right pane (under the Dugan logo) and type a name.
3. Press the Enter key on the keyboard to set the name.
4. To name a channel, select the yellow text and type a name.
5. Press the Enter key on the keyboard to set the name.
Channel naming is cleared by pressing
Channel Pane
The Channel Pane contains the controls and indicators for each channel. Channels
are always in one of three modes:
minates. All transitions are made with a smooth, rapid fade. Select a channel mode
by pressing the individual mode buttons or the Master
Figure 5-3 shows a typical system: channels 1–4 in
nels 5–8 in
.
mute
(see page 48).
reset
,
, or
man
auto
mute
auto
Figure 5-3 Channel Pane
39
Dugan Control Panel Software
. The active channel mode illu-
button.
PRESET
with ambient noise
and chan-
,
Advertisement
Table of Contents
