A J Way chairs must only be used with • designed to assist with. the make and model of electrical components supplied with them which must be kept dry at all times.
Place the cable either in the side any accessories contact either the pocket or on the seat of the chair to therapist involved, your A J Way ensure it does not become entrapped representative, distributor or A J Way and damaged in transit.
Page 4
Most A J Way riser recliners are fitted with the levers back in and reattaching the a remote transformer block which is velcro. attached to a 13 amp plug. The transformer block must not be allowed to Always check that the backrest has been dangle from a high socket.
If the chair does not restart after WARNING: Before first use, the chair approximately 20 minutes please contact should be tested to ensure that all your A J Way representative, distributor or functions are working correctly. A J Way Customer Services Team on 01494 471821.
4.4 Adjusting the chair 4.4.1 Controls Handset .1 Controls Handset The chair has a range of electrically operated adjustments that can be operated using the control handset, specifically: Standing-up (Power-lift) • Legrest Elevation • Back Recline • When the handset is on and ready to use When the handset is on and ready to use WARNING: Take care when adjusting all buttons on the handset should light up...
unintended movement of the support 4.4.3 Lowering the Legrest surfaces. (Button 3) 4.4.2 Elevating the Legrest By pushing Button 3, the legrest will be (Button 2) lowered. At any point during this movement the legrest can be stopped at the desired By pushing Button 2, the legrest will...
4.4.5 Raising the Backrest 4.4.7 Sitting-Down / Lowering the (Button 5) Chair (Button 2) By pushing Button 5, the backrest will raise From the standing position, by pushing slowly to a more upright position. Button 2 the chair will slowly lower to the sitting position.
5.1. Emergency Lowering Device AccuPak is a system which allows the chair to be operated via a mains independent All A J Way Riser Recliner Chairs (except power supply. This enables the user to bariatric chairs) are fitted with a very basic...
5.3 Hazard Sensor Device (Optional) Full functionality of the controls handset • Most A J Way Riser Recliner Chairs may be Any loose or detached parts • fitted with a hazard sensor strip if required. This strip runs around the outside of the Any damage to the fabric of the chair •...
Check that no coins or other objects A J Way representative, distributor or A J have fallen down the sides of the chair Way Customer Services Team: as this can impede the chair’s Check the chair is plugged into the •...
– unplug it and do not use it until it has been repaired. To report a fault please contact your A J Way representative, distributor or A J Way Customer Services Team on 01494 471821.
Should you experience any difficulties or have any concerns regarding the initial purchase or subsequent adjusting of your chair or have any concerns regarding its use or operation then immediately contact your A J Way representative, distributor or A J Way Customer Services Team 01494 471821.