Performing Initial Setup Operations - Sony STR-DE975 Operating Instructions Manual

Performing Initial Setup Operations

Once you have hooked up the speakers and turned on the
power, clear the receiver's memory. Then specify the
speaker parameters (size, position, etc.) and perform any
other initial setup operations necessary for your system.
Clearing the receiver's memory
Before you use your receiver for the first time or when
you want to clear the receiver's memory, do the following.
This procedure is not necessary if the demonstration
activates when you turn the power on.
1/u
MULTI CHANNEL DECODING
? / 1
DISPLAY
SPEAKERS LEVEL
SURR
PRESET
DIMMER EQ
– TUNING + – TUNING +
PHONES
ON SCREEN
MEMORY SHIFT FM MODE FM AM
VIDEO 3 INPUT
VIDEO L AUDIO R
1
Turn off the receiver.
2
Hold down ?/1 for five seconds.
The currently selected function, then the
demonstration message appears in the display and the
items including the following are reset or cleared:
• All preset stations are reset or cleared.
• All sound field parameters are reset to their factory
settings.
• All index names (of preset stations and program
sources) are cleared.
• All SET UP parameters are reset to their factory
settings.
• The sound field memorized for each program source
and preset stations are cleared.
• The master volume is set to VOLUME MIN.
18
MASTER VOLUME
+
–
SET UP
MUTING
CINEMA STUDIO EX DIGITAL CONCERT HALL 6.1 CH DECODING
NAME
A B C A B FUNCTION
INPUT MODE 2ND ROOM
SOUND FIELD MULTI /2CH A. DIRECT
EQUALIZER
A.F.D. MODE 2CH
MODE
ENTER
Performing initial setup operations
Before using your receiver for the first time, adjust SET
UP parameters so that the receiver correspond to your
system. For the adjustable parameters, see the table on
page 62. See pages 19 – 23 for speaker settings and pages
51 – 52 for other settings.
Demonstration Mode
The demonstration will activate the first time you turn on
the power. When the demonstration starts, the following
message appears in the display twice:
"Now Demonstration Mode!! To finish the
demonstration, please press POWER KEY while this
message appears in the display. Thank you!"
To cancel the demonstration
Press ?/1 to turn the receiver off while the above message
is being displayed. The next time you turn the receiver on,
the demonstration will not appear.
To view the demonstration
Hold down SET UP and press ?/1 to turn on the power.
Notes
• Running the demonstration will clear the receiver's
memory. For details on what will be cleared, see
"Clearing the receiver's memory" on this page.
• You cannot cancel demonstration if you did not press
?/1 while the above message is being displayed. To
cancel demonstration after the above message appears,
press ?/1 twice to activate the demonstration again.
Then, press ?/1 while the above message is being
displayed.