Download Print this page

General Pipe Cleaners Hot-Shot 320 Operating Instructions

For use with copper and iron pipe

Hide thumbs

Table of Contents

Quick Links

Download this manual

General Hot-Shot

our Hot-Shot is designed to give you

years of trouble-free, profitable service.

However, no machine is better than its

operator. We therefore suggest you read

these instructions through carefully before

using your machine on the job. This will

enable you to operate the Hot-Shot more

efficiently and more profitably. Failure to

follow these instructions may cause

personal injury to operator or damage to

equipment.

SAVE THESE INSTRUCTIONS!

Operating Instructions

Model 320

(For use with Copper and Iron Pipe)

Before

connecting

pipe

connections

before

receptacle. Make sure all connections are tight to

prevent arcing at the clamps. Loose connections also

get hot and reduce current flow.

the cables. Do not leave any cable coiled up or

placed on steel objects as the heating in the pipe will be

reduced.

™

the

cables.

Make

plugging

unit

Caution:

both

into

Uncoil

Table of Contents

Need help?

Do you have a question about the Hot-Shot 320 and is the answer not in the manual?

Questions and answers

Summary of Contents for General Pipe Cleaners Hot-Shot 320

Page 1 General Hot-Shot ™ Operating Instructions Model 320 (For use with Copper and Iron Pipe) our Hot-Shot is designed to give you years of trouble-free, profitable service. However, no machine is better than its operator. We therefore suggest you read these instructions through carefully before Before connecting cables.
Page 2 Hot-Shot™ malfunction or break down, grounding provides a Safety Instructions low resistance path to carry electricity away from the user. WARNING 2. Avoid body contact with grounded surfaces such pipes, radiators, ranges refrigerators. There is an increased risk of electric Machine must be plugged shock if your body is grounded.
Page 3 Always wear eye protection. Dust mask, non-skid safety shoes, hard • The Hot-Shot 320 puts out 320 amps, yet pulls only hat, or hearing protection must be used for 14 amps. It can clear 1/2" to 1-1/2" pipes up to 100 appropriate conditions.
Page 4 Hot-Shot™ 3. Connect the cables on either side of the frozen 5. If a good connection is made, the pipe and cables section so that they complete an electric circuit. The will vibrate with a 60 cycle hum that you can feel cable clamps must be at least 10 ft.