Subscribe to Our Youtube Channel
Summary of Contents for Iron & Oak SB-05
- Page 1 L L o o g g S S k k i i d d d d e e r r 3-Point Hitch M M o o d d e e l l S S B B - - 0 0 5 5 Owner / Operator and Safety Manual...
- Page 2 Initial Set-up Instructions ❏ ❏ Read all assembly, operating, and safety instructions. ❏ ❏ Complete and return the warranty card to register your log skidder. ❏ ❏ Write the serial number and date-of-purchase in this manual. ❏ ❏ Assemble the log skidder. ❏...
-
Page 3: Table Of Contents
Contents WARNING Introduction ............4 To avoid personal injury or death, carefully read and understand all Safety . -
Page 4: Safety
Introduction Safety The SB-05 Log Skidder attachment is designed for use with small (20 to 60 HP) utility The following is a list of safety rules you must follow in order to use your log skid- sized tractors with hydraulic operating pressures up to 3,000 psi. With up to 2,000 der safely. -
Page 5: Operating Safety
✘ Operating Safety Do not, under any circumstances, alter your log skidder. This equipment was designed and engineered to be used in accordance with the operating instruc- ✔ ALLOW ONLY ONE (1) PERSON TO OPERATE THE LOG SKIDDER. tions. Altering the equipment, or using the equipment in such a way as to cir- cumvent its design capabilities and capacities, could result in serious or fatal ✔... -
Page 6: Maintenance And Repair
ALWAYS raise the log sufficiently off the ground so it can be skidded easily The following chart contains the list of parts that should be shipped as part of the SB-05 without digging into the ground. Note, the height will depend largely on the size Log Skidder. -
Page 7: Start-Up Procedure
WARNING To avoid personal injury or damage to the hydraulic components, do not use the SB-1000 SB-05 Log Skidder with tractor-supplied pressures that exceed 3,000 PSI. CAUTION To avoid bodily injury or machine damage whenever an attachment is 5. Check all hydraulic connections for leaks. -
Page 8: Operation
Operation Locking the Grapple into Position WARNING This procedure allows the grapple to be locked in the 90° position for pick-and-place loading. Do not attempt to operate the log skidder without fully understanding WARNING all our instructions, safety precautions, and/or warnings and those of the tractor. -
Page 9: Decals
Decals Inspection and Maintenance General Maintenance Check (before operating) The hydraulic system (hoses, hose connection, rotating unit, etc.) should be carefully inspected before each use. Also, inspect the mechanical parts at the same time. Make sure all clamps, nuts, bolts, fittings, etc. are properly installed and tightened. WARNING Do not check for leaks with your hand. -
Page 10: Parts Section
Parts Section Iron & Oak Commercial Products, Inc. 815-672-8596 815-672-8596 Iron & Oak Commercial Products, Inc. - Page 11 SB-1007 SB-1009 Iron & Oak Commercial Products, Inc. 815-672-8596 815-672-8596 Iron & Oak Commercial Products, Inc.
-
Page 12: Warranty
Warranty For one year from the date of purchase, Iron & Oak Commercial Products Inc. will replace for the original purchaser, or repair free of charge, all parts of the Iron & Oak Hydraulic Log Skidder, returned to our factory PREPAID and found upon inspection by us to be faulty, due to defects in materials or workmanship. - Page 13 Notes...
- Page 14 Notes...
- Page 15 Iron & Oak Commercial Products, Inc. 410 W. Broadway Ave. Streator, Illinois 61364-0577 Phone: 815-672-8596 Fax: 815-672-9073 E-mail: sales@logsplitters-ironoak.com Web Site: www.logsplitters-ironoak.com SB-05-00 03/05...
Need help?
Do you have a question about the SB-05 and is the answer not in the manual?
Questions and answers