Page 2
Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities If the power cord is damaged, it must be replaced by a APURO agent or a recommended qualified technician in order to avoid a hazard ...
Page 3
Telephone Helpline: 130 0225960 Installation Ensure you have adequate support to support the appliance and proceed to drill and install the fixing screws Once the screws are installed, locate the appliance on the wall by aligning the locating holes on the back plate with the screws.
Page 4
Always turn off the appliance and disconnect from power supply before cleaning. Warm soapy water is recommended for cleaning. Cleaning agents may cause damage or leave harmful residues when used for a prolonged period on stainless steel. A APURO dealer or qualified technician should carry out repairs if required.
Page 5
Replace bulb (Bulb must have a light wave length of 253.7nm – please contact your retailer) Plug and lead are damaged Call APURO agent or qualified technician Fuse in the plug has blown Replace the plug fuse Power supply Check Power Supply...
Page 6
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of APURO. Every effort is made to ensure all details are correct at the time of going to press, however, APURO reserve the right to change specifications without notice.
Page 7
DECLARATION OF CONFORMITY Equipment Type Knife Steriliser Model DM079-A C-Tick Legislation AS/NZ 3820 Essential Safety Requirements for Low Voltage Electrical Equipment EN 55014-1:2006+A1: 2009+A2: 2011 Standards EN 61000-3-2: 2006+A1:2009+A2:2009 EN 61000-3-3:2008 EN 55014-2: 1997+A1: 2001+A2: 2008 IEC 60335-1:2012 EN62233:2008 Producer Name...
Need help?
Do you have a question about the DM079 and is the answer not in the manual?
Questions and answers