Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zeagle Envoy RaZor
Summary of Contents for Zeagle Envoy RaZor
- Page 1 Envoy RaZor Owner’s Manual www.zeagle.com...
-
Page 2: Table Of Contents
Pages Table of Contents: Introduction – Safety Information Warranty Information Disclaimer and Limitation of Remedy Nitrox Use RaZor First Stage Features Second Stage Features Pre-Dive Lever Octopus Use Wet Breathing Pre-Dive Check Post-Dive Care Maintenance Specifications Service Record... -
Page 3: Introduction - Safety Information
This owner’s manual uses signal words recommended by the American National Standards Institute (see ANSI Z535.4) to des- ignate levels of hazard seriousness. These signal words and their designations are as follows: DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. This signal word is to be limited to the most extreme situ- ations. - Page 4 Congratulations on your Zeagle Regulator purchase! Your new Zeagle Envoy Razor regulator has been designed and manufactured to the highest possible standards of performance and reliability. With the reasonable care outlined in this manual it will provide you with many years of diving enjoyment.
-
Page 5: Warranty Information
Under this limited warranty, Zeagle will either repair or replace, at its sole option, any original equipment or parts that fail to perform as intended. -
Page 6: Disclaimer And Limitation Of Remedy
4. This limited warranty applies only to the original purchaser, and then only to certified divers. 5. Sometimes products from other manufacturers are attached to Zeagle equipment. This warranty does not cover those other prod- ucts or make any claims as to the performance or suitability of those other products. - Page 7 2. Zeagle regulators must be serviced only by dealers or technicians trained and authorized to service Zeagle Scuba equipment. At no time should any unauthorized person attempt to repair the regulator or adjust any nuts, bolts or screws other than those used to mount the regulator to, or dismount it from the tank valve.
-
Page 8: Nitrox Use
NITROX USE Zeagle regulators are manufactured using materials suitable for use with oxygen enriched gases (i.e., Nitrox, etc.) providing the oxygen content does not exceed 40%. The regulator must be kept “Oxygen Clean”... -
Page 9: Razor First Stage Features
The RaZor reduces the high pressure air contained in the cylinder to a constant intermediate pressure of approximately 135 psi (9.2 BAR). Zeagle first stages are designed to do this with outstanding reliability. - Page 10 RaZor (continued) fig. 1 When the valve handwheel is turned off, tank pressure is applied to the safety relief burst disc, but not the HP (high pressure) port or the regula- tor section of the RaZor. When the diver is ready to use the RaZor, the valve handwheel is turned in a counter-clockwise direction until it is fully open.
- Page 11 RaZor (continued) fig. 2 Zeagle recommends that a Zeagle LP Port Pressure Port Relief Valve p/n 330-4905 always be installed in a low pressure port of any regulator that is left turned on unattended for extended periods of time, such as a Safety Stop Hang Bottle.
- Page 12 RaZor’s tank. fig. 3 The Fill Valve Cap is then replaced. The RaZor can also be filled from a Yoke Valve on a larger tank by using the Zeagle Transfiller p/n 330-6050 (see fig. 5 below) fig. 5 fig. 4...
-
Page 13: Second Stage Features
SECOND STAGE FEATURES The Zeagle Envoy second stage is pneumatically balanced and is among the most advanced diver adjustable breathing systems avail- able. No fixed or “automatic” system can achieve an ideal level of breathing performance under all conditions. DIVE/PRE-DIVE VENTURI LEVER This lever controls the sensitiv- ity of the regulator. -
Page 14: Octopus Use
OCTOPUS (Alternate Second Stage) USE The diver controls available on the Zeagle standard Envoy second stage make it an excellent choice for Octopus use. An Octopus Regulator is often subjected to conditions that may cause a free-flow. For example, jumping into the water or swimming in a strong current. - Page 15 4. Turn the tank valve on slowly, check for air leaks and proper breath- ing function of the regulator. If any unusual leaks are heard, do not dive with the regulator. Take the regulator to your authorized Zeagle dealer for inspection and repair if necessary.
-
Page 16: Post-Dive Care
MAINTENANCE It is essential that your regulator is checked at least annually by an authorized Zeagle regulator technician. Unusually heavy use, or use in dirty or contaminated water may result in the need for more fre- quent service. A service record has been provided at the end of this... -
Page 17: Specifications
A. FIRST STAGE REGULATOR MODEL: RaZor FEATURES: Flow-by Piston, Valve-Regulator Combination screws directly into standard Scuba cylinder. 1.62 lb. (.73 kg.) WEIGHT 120-150 psi (8-10 bar) INTERMEDIATE PRESSURE # LOW PRESSURE PORTS # HIGH PRESSURE PORTS MATERIALS: Brass Body O-rings Buna-N Teflon Seat... -
Page 18: Service Record
Service Record Date: Service: Date Purchased: - - - - - - - - -... - Page 19 Notes: The date of purchase, dive store, and contact informa- tion for the store, should be written on this page. A copy of the receipt could also be stapled to this page for future records.
- Page 20 Zeagle Systems Inc. 3585 Cadillac Ave Ste A Costa Mesa, CA 92626-9814 Toll Free: 888-270-8595 Fax: 714-375-1435 www.zeagle.com...