Advertisement
2.
INTRODUCTION
Ratchet type axle stands, all steel construction with additional pin and chain load support. Quick start feature operated by pulling the lever once with
the crutch rising automatically to meet the axle or chassis of the vehicle. Full width V-crutch for safe support of load. Manufactured to rigorous safety
standards. Sold in pairs.
3. SPECIFICATION
N.B. In order to obtain the capacities shown, the vehicle must
be evenly supported by the two stands.
Model no: ................................................................. AAS3000
Capacity each: .............................................................1.5tonne
Capacity pair: .................................................................3tonne
Minimum height: ............................................................340mm
Maximum height: ...........................................................510mm
Model no: ................................................................. AAS5000
Capacity each: .............................................................2.5tonne
Capacity pair: .................................................................5tonne
Minimum height: ............................................................400mm
Maximum height: ...........................................................620mm
Model no: ............................................................... AAS10000
Capacity each: ................................................................5tonne
Capacity pair: ...............................................................10tonne
Minimum height: ............................................................505mm
Maximum height: ...........................................................770mm
4. ASSEMBLY
Note: Figures 1,2 and 3 are for representational purposes only.
4.1.
Insert centre column into base frame, see fig.1.
4.2.
Ensure the toothed side of the column engages with the locking lever
mechanism.
4.3.
Bend in the locking tab using a drift or similar and a hammer, see fig.1.
5. OPERATION
5.1.
Refer to manufactures instructions for recommended jacking/support points.
check to ensure jacking/support points are in good condition.
5.2.
Position the stands beneath their support points.
5.3.
To adjust the stands: Hold the control lever up and the gas strut will raise the
centre column to the required height. Push the control lever down to lock the
pawl into the central column teeth (fig.2 and fig.3).
WARNING! ENSURE PAWL IS FULLY ENGAGED WITH TEETH.
‰
5.4.
Carefully and slowly lower vehicle onto stands. Ensure load bearing points sit in
the centre of the saddles and that the stands are stable. Also ensure that there
are no objects or persons that could impede the safe lowering of the vehicle
onto the stands.
▲
DANGER! You must follow THESE instructions carefully and ensure you
DO NOT load the stands off centre. Failure to adhere to these warnings may
cause damage, injury or loss of life!
5.5.
Insert the locking pin to store the stands in their lowest position.
© Jack Sealey Limited
fig.2
Original Language Version
fig.1
fig.3
AAS3000, AAS5000, AAS10000 | Issue 3 25/08/16
Advertisement
