Advertisement
Muti-Function High Chair
#267
Function:Booster
Function:Junior Chair
Function:High Chair
suitable for 6-24 months
suitable for 24-60 months
suitable for 6-36 months
IMPORTANT: READ CAREFULLY AND
RETAIN FOR FUTURE REFERENCE
Do not discard any packaging until you have all the components and fittings.
Read the instructions before constructing the product then follow them step by step.
You may find the construction of your product easier with the help of another person.
WARNING:DO NOT use the product without seat pad!
Parts
Advertisement
Table of Contents
Summary of Contents for DOM 267
- Page 1 Muti-Function High Chair #267 Function:Booster Function:Junior Chair Function:High Chair suitable for 6-24 months suitable for 24-60 months suitable for 6-36 months IMPORTANT: READ CAREFULLY AND RETAIN FOR FUTURE REFERENCE Do not discard any packaging until you have all the components and fittings.
- Page 2 3. Slot the two rear legs into the rear housing on the seat. push the pins 1. Slot the two upper front legs into the on the legs inwards and fully insert foot rest. into the housing. Ensure that the foot rest plastic is Ensure the pins are protruding stuck into the hole on the legs.
- Page 3 8. Place the seat pad in the seat. Slot the buckles on the ends 9. Slot the tabs on the waist straps into the buckle (1). of the harness straps through the slots in the seat pad and To adjust the harness. Slide the straps through the slot the buckles through the slots in the seat.
- Page 4 12. Press the catch on the top of the tray support inwards (1) and lift the tray upwards off the high chair (2) & (3). 13. Rotate the support up (1) to pick off the tray support from the seat (2). Use the key to unlock the support bar.
- Page 5 15. Push the pins (1) inwards to pull the four legs (2). 17. Fasten the booster to an adult chair. place the 16. Slot the buckle at the end of two harness (a) & (b) into booster on the chair taking care that chair surface the housing under the seat as the right picture (1) shown.
- Page 6 Care & Maintenance 1. The high chair can be cleaned by sponging with warm water and a mild detergent. A mild disinfectant may be used. 2. Stubborn marks may be removed with a non-abrasive cream cleaner. Never clean with abrasive, ammonia based, bleach based or spirit type cleaners. 3 Do not use if any part is broken, torn or missing 4 Keep the chair in a dry place 5 All the moving parts should be kept clean.
- Page 7 BEFORE YOU USE THE PRODUCT AS THE BOOSTER CHAIR POSTION, PLEASE CAFULLY READ BELOW WARING STATEMENT.FAILURE TO FOLLW THESE WARNINGS COULD RESULTIN SERIOUS INJURY OR DEATH. 1.Prevent serious injury or death from sliding out, falls or tipping over. Do not use in motor vehicles.
Need help?
Do you have a question about the 267 and is the answer not in the manual?
Questions and answers