Instruction manual MICROCLEAN - Denture cleaning unit Contents Chapter Page Technical data.........................3 Brief description (correct use)..................4 Installation........................4 Controls..........................5 Operation.........................6 Working procedures......................6 Trouble shooting......................8 Operating the unit......................9 Maintenance/Servicing....................9 Transport and packaging.....................10 Safety .........................11 General Data/Disposal....................12 General hazard notes....................13 10.1 Danger zone........................13 10.2...
Page 3
Instruction manual MICROCLEAN - Denture cleaning unit Dear Customer Congratulation on your purchase of our MICROCLEAN Denture cleaning unit! Schütz Dental GmbH thanks you for your trust! If you should need any information or have special questions on this system, our complete team of...
Noise level: < 65 dB (A) Brief description (correct use) The Microclean cleaning unit was developed for cleaning and compacting the surfaces of metals and acrylics. This unit was designed to create a magnetic field which reverses its polarity every two minutes when running.
Instruction manual MICROCLEAN - Denture cleaning unit Installation Remove the packaging. • Place the unit on a nonskid surface. • Plug the power cable of the unit into the power supply. • Controls timer + mainswitch Schütz Dental GmbH page: 5/15...
Instruction manual MICROCLEAN - Denture cleaning unit Operation Working procedures Prepare the castings for polishing as usual using burs and rubber polishers. Very hard areas of CoCrMo alloys or „alpha-case“ on titanium can be removed with burs and sandblasting. The various cleaning fluids are for use with precious alloys, dentures, facing materials, CoCrMo alloys and titanium (refer to the table).
Page 7
Instruction manual MICROCLEAN - Denture cleaning unit Disposal! Look at chapter 9, page 12. The following table shows the amounts and cleaning periods. The table assumes that 150 g of pins and 150 ml of water are used. MICROCLEAN table cleaning fluid - orange (universal), 500 ml, order no.: 678855, for following applications:...
Instruction manual MICROCLEAN - Denture cleaning unit cleaning fluid - green (acidic), 500 ml, order no.:678857 for the following applications: - Removing oxides from precious metals after divesting. - Removing oxides from previous metals immediately after firing porcelain. - Cleaning deposits and calculus off dentures.
Instruction manual MICROCLEAN - Denture cleaning unit Operating the unit 1.) Place the restoration in the fluid in the plastic vessel and close the lid tightly. 2.) In order to avoid rotation of the cleaning vessel, set a paper towel between unit and black beaker mount (acrylic top).
Instruction manual MICROCLEAN - Denture cleaning unit Transport and packaging All Schütz Dental units and systems are carefully inspected before they are packed and dispatched. However, damages during transport can not be ruled out. Incoming inspection: Check for completeness of the consignment, according to delivery note!
Instruction manual MICROCLEAN - Denture cleaning unit Safety When operating the Microclean, keep equipment or objects which may be affected or damaged by powerful magnetic fields approximately 0.5 m from it. The relevant regulations for prevention of accidents must be heeded!
Instruction manual MICROCLEAN - Denture cleaning unit General Data/Disposal Disposing of the unit: This unit consists mainly of electrical and electronic components. Note on environmental protection Electrical and electronic devices, batteries and rechargeable batteries may not • be disposed of with domestic waste.
Instruction manual MICROCLEAN - Denture cleaning unit General hazard notes 10.1 Danger zone The danger zone is considered to be the area within 1 m of the unit as this is the area required by the staff for operating it.
Instruction manual MICROCLEAN - Denture cleaning unit 4. The user must refrain from anything which risks the safety of this unit. 5. The user must ensure that no unauthorized persons have access to this unit. 6. The user is obliged to report any changes in the unit, which may adversely affect its safety, to the operator.
Instruction manual MICROCLEAN - Denture cleaning unit Guarantee This unit has been constructed and manufactured under consideration of all safety regulations. Should the unit show any manufacturing errors or irregularities during the guarantee period, they will be fixed by the manufacturer according to our standards. For any guarantee claim, the invoice or delivery note must be provided as proof.
Need help?
Do you have a question about the MICROCLEAN and is the answer not in the manual?
Questions and answers