Page 1
We are confident you will be pleased with the results you will attain with your Dr.Trainer. Please remember you will get better results with the use of lower shock combined with consistent training techniques. The use of high levels of shock should only be used as a last resort and in life-threatening situations.
Page 2
Important Safety Information Not for use with aggressive dogs. Do not use this product if your dog is aggressive, or if your dog is prone to aggressive behavior. Aggressive dogs can cause severe injury and even death to their owner and others. If you are unsure whether this product is appropriate for your dog, please consult your veterinarian or certified trainer.
Table of Contents How the System Works………………..…………………………………………….5 Features……………………………………………………………………………………5 Key Definitions……………………………..……………………………………………..6 Operating Guide………………………..………………………………………..11 Prepare the Remote Transmitter………………..…………………………………11 Charge the Remote Transmitter………………..…………………………..11 Turning ON the Transmitter…………………………..………………………11 Transmitter Digital Display………………………………..…………………..11 Transmitter Battery……………………………………………..……………….11 Prepare the Receiver Collar……………………………………………..………….12 Charge the Receiver Collar……………………………………………..……12 To Turn the Receiver Collar On………………………………………..…….12 To Turn the Receiver Collar Off………………………………………..…….12 Test the Shock Function…………………………………………………………..….13 Fit the Receiver Collar…………………………………………………………..……..14...
Page 4
Components COLLAR RECEIVER FOR DOG 1 COLLAR RECEIVER FOR DOG 2 FOR 2-DOG SYSTEM, MODEL TS1-2 ONLY REMOTE TRANSMITTER SMART DOG TRAINING COLLAR TS1-1/TS1-2 TEST LIGHT OWNER’S MANUAL BATTERY CHARGER WRIST STRAP...
The Dr.Trainer has been proven safe, comfortable, and effective for both small and large dog breeds. Important: The Dr.Trainer has a range of up to 500 yards. Depending on the way you hold the Remote Transmitter, the maximum range may vary.
Key Definitions Remote Transmitter: Transmits the signal to the Receiver Collar. It is waterproof. Digital Display Dog 1: The active collar symbol will display to indicate Dog 1. Dog 1 and Dog 2 symbols will be displayed and switched (additional purchase required for 2 dog system).
Page 7
Level of Shock: Shows Dog 1 or Dog 2 level of Shock (Low-1 to High-10). Level of Vibration: Shows Dog 1 or Dog 2 level of Vibration (Low-1 to High-5). Remote Battery Indicator: The battery indicator provides constant awareness of the remote battery’s power level. Receiver Battery Indicator: The battery indicator provides constant awareness of the receiver battery’s power level.
Page 8
Switch Button: Switch between dog 1 and dog 2. Only available on 2-dog system. Additional purchase required for 2 dog system. Voice Button: Produces a positive training tone, which can be customized on the receiver, from the collar. No shock is delivered. Vibration Button: Deliver a continuous vibration on the receiver to the dog.
Page 9
RECORDING BUTTON POWER BUTTON Recording Mic STATUS LIGHT CONTACT POINTS CHARGING JACK Receiver Collar: Delivers shock or warning tone on a signal from the Remote Transmitter. Power Button: Long pressing and holding this button for 2 seconds turns the Receiver Collar on and off.
Page 10
Contact Points: The contacts through which the Receiver Collar delivers shock. The contact points will pop up and pull back, when they are activated. Status Light: Indicates when the Receiver Collar has been turned on or off and also serves as a battery charging indicator. Charging Jack: For connecting the charger.
Operating Guide STEP 1: Prepare the Remote Transmitter Charge the Remote Transmitter 1.Locate the Charging Jack under the Remote. 2.Connect one of the charger connectors to the Remote Transmitter Charging Jack. 3.Plug the charger into a standard wall outlet. 4.Charge the Remote Transmitter. Note: The Battery Indicator on the screen and the status light will indicate the charging process.
STEP 2: Prepare the Receiver Collar Charge the Receiver Collar 1.Lift the rubber cover protecting the Receiver Collar Charging Jack. 2.Connect the charger connector to the Receiver Collar Charging Jack. 3.Plug the charger into a standard wall outlet. 4.Charge the Receiver Collar, the red LED light will blink, charge until the Green Indicator Light comes on and is solid, indicating a full charge.
STEP 3: Test the Shock Function To ensure the shock function works properly before using the collar on your dog, it is recommended that you should test the shock function at least once before use. Please follow below instructions on how to use the test light to test.
STEP 4: Fit the Receiver Collar Important: The proper fit and placement of your Receiver Collar is important for effective operation. To assure a proper fit, please follow these steps: 1.Make sure that the Receiver Collar is turned off. 2.Start with your dog standing comfortably. 3.Place the Receiver Collar on your dog’s neck close to the ears.
Page 15
Pairing Guide The remote and the receiver are paired by default at factory. In case you want to repair them, please follow below instructions. STEP 1: Enter pairing mode Holding the two minus buttons “-” on both side on the remote at the same time for 3 seconds, the DOG 1 (or DOG 2) sign on the remote screen starts to blink, indicating the remote is ready to pair with the receiver.
Q: How old does a pet have to be before using the Dr.Trainer? Your pet should be able to learn basic obedience commands such as “Sit” or “Stay.” Pets should be at least 6 months old before using the Trainer.
Page 17
FAQ’s Q: Why my pet is not responding when I press a button? •Check to see if the Receiver Collar has been turned on. •If your range has reduced from the first time you have used it, please check to see if the battery is low in either the Remote Transmitter or Receiver Collar.
Page 18
IMPORTANT! Please noted that, as the maximum shock level can be detrimental to dogs that are sensitive to electric shock and different breeds of dog react differently to the same level of shock stimulation, it is highly recommended that you should always start from the lowest intensity level, i.e.
Page 19
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Need help?
Do you have a question about the TS1 Series and is the answer not in the manual?
Questions and answers