Advertisement
~
ASSEMBLYINSTRUCTIONS
fL
2
~
~
l')
/
1
1(1
-
Hook The shoulder straps to the top and
bottom
of the sprayer (Fig. 1), adjusting the
straps so the sprayer can be carried comfortably.
-
Assemble the lance (Fig: 2), screwing the extension and the desired nozzle together.
-
When using the sprayer far the first time check the battery status and recharge if
necessary (Fig.3) :
. connect the battery charger to the pump
.
connect battery charger to 220V - 50Hz circuit
.
battery in fully charged when the red Led comes on.
. disconnect the battery charger and the sprayer is ready far the use.
USEINSTRUCTIONS
4
~,w~
5
6
~
~,
~
[I§!I
~~
-
USE ONL Y LIQUID- BASED PRODUCTS
-
Before using, check the operation of the pump (use only clear water)
-
In another container, mix chemicals and water. Follow instructions of the producer.
-
Pour the liquid-mix into the tank. Make sure the filter is in the tank mouth.
Be careful as not to pour the liquid on the ground.
-
Correctly piace the pump on your shoulder, then set the speed selection switch
( O=stop; l=slow; 2=fast) ( Fig.4).
-
Squeeze the hand ever to engage the elctric pump. Relugate the output
( mist or long) by turning the lance's head (Fig.5).
-
DO NOT OPERATE THE PUMP
WITH
AH EMPTY TANK.
-
In case the nozzles becomes clogged: stop spraying, and remove the nozzle from
the lance. Clean the ho le using a jet of water or a small brush ( do not blow on it
with your mouth). Wear gloves while cleaning to avoid contact with the liquid
( Fig.6).
-
When finished spraying, pour the remaining liquid into another container. Rinse
.
Out the thank, and operate the pump with clear water far severa I minutes.
Advertisement
