Sony DAV-X1V Operating Instructions Manual page 30

C To connect the OPTICAL DIGITAL OUT jack of a component to the
DIGITAL IN OPTICAL jack of this system
Connect the component to the DIGITAL IN OPTICAL jack using a optical digital cord (not supplied).
Note
• Make sure that the connected jack combinations are correct; if you connect the audio cords to VIDEO 1 (AUDIO
IN), you should connect the video cord to VIDEO 1 (S-VIDEO IN/VIDEO IN).
• When you connect to the VIDEO 1 DIGITAL IN OPTICAL or COAXIAL jack, set the switch on the rear panel
accordingly.
If you connect a digital satellite receiver with a DIGITAL OUT (COAXIAL
or OPTICAL) jack
The digital satellite receiver can be connected to the VIDEO 1 DIGITAL IN OPTICAL or COAXIAL
or VIDEO 2 DIGITAL IN COAXIAL jack instead of the VIDEO 1 or VIDEO 2 AUDIO IN jacks of
the system.
The system can accept both the digital and analogue signals. Digital signals have priority over analogue
signals. If the digital signal ceases, the analogue signal will be processed after 2 seconds.
If you connect a digital satellite receiver without a DIGITAL OUT jack
Connect the digital satellite receiver to the VIDEO 1 or VIDEO 2 AUDIO IN jacks only of the system.
Note
• Be sure to make connections securely to avoid hum and noise.
To listen to the portable audio source sound through the system
Connect the audio output jacks of the portable audio source to the AUDIO IN jack on the front panel
of the system with the stereo mini-plug cord (not supplied).
Tip
• When listening to MP3 format recordings using a portable audio source, you can enhance the sound.
Press FUNCTION +/– to select "AUDIO." Connect the portable audio source. Press SOUND FIELD repeatedly
until "P.AUDIO" appears in the front panel display.
To cancel, select other than "P.AUDIO."
30
US
OPTICAL COAXIAL COAXIAL
VIDEO1
VIDEO2
DIGITAL IN
System