Adjusting The Speaker Level By Using The Test Tone - Sony DAV-FX500 Operating Instructions Manual

x [DISTANCE (SURROUND)]
The default distance setting for the speakers in
relation to the listening position is shown below.
When you set the distance using the Quick Setup
(page 18), the settings is automatically
displayed.
Be sure to change the value in the Setup Display
when you move the speakers.
[L/R] Surround speaker distance from
3.0 m/10 ft *
the listening position can be set in
(appears when you
0.2 meter (1 ft) increments from
set [SURROUND]
0.0 to 7.0 meters** (0 to 23 ft).
to [YES] in the
[SIZE] setting.)
* When you perform the Quick Setup (page 18), the
default settings are changed.
** 0.0 to 6.9 meters for North American models.
Note
• When you set the distance, the sound cuts off for a
moment.
• Depending on the input stream, the [DISTANCE]
setting may not be effective.
• When the speaker distance setting is not in the
recommended range,
being the number). indicates over the
recommended distance.
x [LEVEL (FRONT)]
You can vary the level of front speakers as
follows. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
[L/R]
Set this between –15.0 dB and
0.0 dB
+10.0 dB in 1.0 dB increments.
/ ** m is displayed (**
indicates below.
[CENTER] Set this between –15.0 dB and
0.0 dB
+10.0 dB in 1.0 dB increments.
(appears when you
set [CENTER] to
[YES] in the [SIZE]
setting.)
[SUBWOOFER] Set this between –15.0 dB and
0.0 dB
+10.0 dB in 1.0 dB increments.
x [LEVEL (SURROUND)]
You can vary the level of surround speakers as
follows. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
[L/R] Set this between –15.0 dB and
0.0 dB
+10.0 dB in 1.0 dB increments.
(appears when
you set
[SURROUND] to
[YES] in the
[SIZE] setting.)
To adjust the volume of all the
speakers at one time
Press VOLUME +/– on the system, or press
VOLUME +/– on the remote.
x [TEST TONE]
The speakers will emit a test tone to adjust
[LEVEL (FRONT)] and [LEVEL
(SURROUND)].
[OFF] The test tone is not emitted from the
speakers.
[ON]
The test tone is emitted from each speaker
in sequence while adjusting level. When
you select one of the [SPEAKER SETUP]
items, the test tone is emitted from each
speaker in sequence.
Adjusting the speaker level by
using the test tone
1
Press DISPLAY when the system is
in stop mode.
The Control Menu appears.
2
Press X/x to select
then press .
The options for [SETUP] appear.
3
Press X/x to select [CUSTOM], then
press .
[SETUP],
continued
79
US