Long-Term Storage - Land Pride BB3578 Operator's Manual

Section 4: Maintenance

Long-Term Storage

Clean, inspect, service, and make necessary repairs to
the implement when storing it for long periods and at the
end of the season. This will help to ensure the unit is
ready for field use the next time you hook-up to it.
1. Clean off any dirt that may have accumulated on the
scraper and blades. Scrape off compacted dirt and
then wash surfaces thoroughly with a garden hose.
2. Check grader blades and plow bolts for wear and
replace if necessary. For additional instructions, see
"Cutting Blades" on page 12.
3. Check for bent and sprung shanks. Bent shanks will
be bent to one side. Sprung shanks will have shank
tips lower than the other tips. Replace damaged
shanks with genuine Land Pride shanks.
4. Check for loose and missing shank tips and shank
tips with high wear, Replace tips as needed. For
replacement instructions, see "Shank Tips" on page
12.
5. Inspect Box Scraper for loose, damaged, or worn
parts. Adjust and tighten loose parts. When needed,
replace parts with genuine Land Parts only.
6. Repaint parts where paint is worn or scratched to
prevent rust. Ask your dealer for Land Pride aerosol
touch-up paint. They are also available in touch-up
bottles with brush, quarts, and gallon sizes by adding
TU, QT, or GL to the end of the aerosol part number.
Land Pride Touch-up Paint
Part No. Part Description
821-011C PAINT LP BEIGE SPRAY CAN
821-066C PAINT ORANGE SPRAY CAN
821-070C PAINT GP GLOSS BLACK SPRAY CAN
7. A light coating of oil or grease may be applied to the
lower Shank Bars, inside the mold board and inside
the side panels in lieu of paint to minimize oxidation.
8. Replace all damaged or missing decals.
9. Store Box Scraper on a level surface in a clean, dry
place. Inside storage will reduce maintenance and
make for a longer scraper life.
11/7/18
Table of Contents
Ordering Replacement Parts
Land Pride offers equipment in factory standard Beige
with black highlights. This implement may also be
purchased in Orange, Green, or Red.
When ordering an optional color, the suffix number
corresponding to the color must be added at the end of
the part number. Parts ordered without the suffix number
will be supplied in factory standard colors.
82 . . . . . . . Orange
85 . . . . . . . Black
For example, if you are ordering a replacement part with
part number 555-555C and the existing part is orange,
then add the suffix 82 to the end of the number to make
the part number read 555-555C82.
BB3578, BB3584, & BB3596 Fixed Bar Box Scraper 303-398M
13