Advertisement
Monitor Stand-Basic
75x75
SO-MS001-BK
100x100
Parts List
Installation Manual
Spring Arm Installation
Step1
Step2
32''
8Kgx2
MAX
(17.6lbsx2)
RATED
A: VESA monitor
B: Arm(x1)
mount(x2)
F: Hex key
D: Center pole(x1)
E: Pole cap
(x1)
holder (x1)
I:Round head
K
Flat head
:
J: Rubber
:
L
Grommet
screw (x2)
screw
plate(x1)
pads(x5)
(x3)
D
Option A-clamp mounting
J
K
C
Insert three flat head screws(K) to attach
desk clamp(C) to the center pole(D)
C : Desk clamp
M4x12(x8)
M4x16(x8)
(x1)
M-A
G: Grommet top
H: Screw cap
M5x16(x8)
D(x8)
plate (x1)
(x2)
M-D
M: 4mm(x1)
N: 6mm(x1)
Hex key
E
Insert cap
to center pole
(E)
Option B-through hole mounting
C
M
G
J
L
After adding the rubber pads to the grommet
top plate(G) and use the pre-installed screw to
combine the center pole(D) to it
M5x12(x8)
M-B
M-C
M-C(x8)
M-E
(D)
Advertisement
Table of Contents
Related Manuals for Solos SO-MS001-BK
Summary of Contents for Solos SO-MS001-BK
-
Page 1: Parts List
Insert cap to center pole Step2 Option A-clamp mounting Option B-through hole mounting 32’’ 75x75 SO-MS001-BK 8Kgx2 100x100 (17.6lbsx2) RATED Insert three flat head screws(K) to attach After adding the rubber pads to the grommet desk clamp(C) to the center pole(D) - Page 2 Step3 Step5 Tip：Attaching a monitor is a two-person job. Do not attempt to complete this task by yourself. Attach the arm(B) to center pole(D) by using the 6mm hex alley to tighten the pre-installed screw VESA Installation Step4 Snap monitors onto the arm and insert the round head screws(I) to tighten it Use different set of screw according to your monitor size...
- Page 3 Step6 Step7 You can adjust SOLOS Monitor Stand-Basic in the following ways: Please avoid the following adjustment CAUTION: Use with products heavier than the rated weights indicated may result in instability, causing possible injury. • Mounts must be attached as demonstrated in assembly instructions. Improper installation may result in damage or serious personal injury.
Need help?
Do you have a question about the SO-MS001-BK and is the answer not in the manual?
Questions and answers