TriPollar STOP V User Manual

TriPollar STOP V User Manual

Facial renewal and rejuvenation

Advertisement

FACIAL
RENEWAL AND REJUVENATION
USER MANUAL
ENGLISH

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STOP V and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for TriPollar STOP V

  • Page 1 FACIAL RENEWAL AND REJUVENATION USER MANUAL ENGLISH...
  • Page 2 ENGLISH Congratulations on purchasing your TriPollar STOP V device! You have taken the first step toward flawless beautiful skin! This user manual describes the TriPollar STOP V product and how to use it.
  • Page 3: Table Of Contents

    TABLE OF CONTENTS INTRODUCING TRIPOLL AR STOP V • OVERVIEW • THE TRIPOLL AR STOP V KIT USING TRIPOLL AR STOP V • THE TRIPOLL AR STOP V DEVICE • BEFORE YOU BEGIN • TRE ATING YOUR SKIN • RECOMMENDED TRE ATMENT GUIDELINES...
  • Page 4 Design and technical specifications are subject to change without prior notice. Manufactured by Pollogen Ltd. Patented technology. The names Pollogen, TriPollar and STOP are registered trademarks of Pollogen Ltd. All intellectual property rights in this publication are owned by Pollogen Ltd.
  • Page 5 To learn more about TriPollar technology, visit our website at www.stop-age.com. WARNINGS AND CAUTIONS TriPollar STOP V is an electrical device that must be used properly. To reduce the risk of injury, adhere to all warnings and cautions below: • Do not touch the device should it fall into water. Unplug the device immediately with dry hands.
  • Page 6 • Use STOP Preparation Gel during treatment according to its instructions for use. SAFETY INSTRUCTIONS • Only use this device for its intended purpose, as described in this manual. • Do not use the device over eyelids, closed eyes, thyroid area, lips, ears, breasts or genital areas.
  • Page 7 • Have any active skin condition within the treatment area, such as sores, psoriasis, eczema or a rash. • Have a history of keloid scarring, abnormal wound healing or fragile skin. • Have had any surgical procedure, laser resurfacing or deep chemical peeling in the treatment area within the past three months or are still undergoing a healing process.
  • Page 8 POSSIBLE SIDE EFFECTS The following side effects are rare. However, should they occur, they are usually temporary. If any of the following conditions appear and last more than 24 hours, consult your physician: • Pain • Damage to natural skin texture (crusting, blistering, burns, fragile skin, bruising) •...
  • Page 9: Introducing Tripollar Stop V

    The TriPollar STOP V system is intended for non-invasive skin renewal at home, specifically indicated for skin tightening and treatment of wrinkles. When the TriPollar STOP V device is used properly in accordance with the recommended treatment protocol, it effectively postpones the signs of aging.
  • Page 10: The Tripollar Stop V Kit

    THE TRIPOLLAR STOP V KIT The TriPollar STOP V kit contains the following components: 1. TRIPOLLAR STOP V KIT (FIG.1) FIG.1...
  • Page 11 2. TRIPOLLAR STOP V DEVICE (FIG.2) 3. TRIPOLLAR STOP V POWER SUPPLY AND ELECTRIC CORD (FIG.3) 4. TRIPOLLAR STOP V ELECTRICAL OUTLET ADAPTERS (FIG.4) 5. STOP PREPARATION GEL (FIG.5) After the container has been opened, the gel can be used for up to 12 months.
  • Page 12: Using Tripollar Stop V

    USING TRIPOLLAR STOP V This chapter describes the TriPollar STOP V device and how to use it. THE TRIPOLLAR STOP V DEVICE The TriPollar STOP V device is used to increase and accelerate collagen production for skin renewal. TriPollar STOP V focuses heat deep within the dermis. The TriPollar STOP V’s DMA technology targets the SMAS layer, as shown below.
  • Page 13 The components comprising the TriPollar STOP V device: FIG.8 1. DEVICE BODY 2. TREATMENT HEAD 3. ELECTRODE 4. TEMPERATURE SENSOR 5. POWER SUPPLY CONNECTION 6. GREEN/BLUE INDICATOR LIGHT 7. ORANGE INDICATOR LIGHT 8. ON/OFF BUTTON 9. LOW RF 10. HIGH RF 11.
  • Page 14 The indicator lights on the TriPollar STOP V device works as follows: GREEN LIGHTS INDICATE RF MODE • A single green light means that the device is ON and is operating in low- level RF mode. • Two green lights mean that the device is operating in high-level RF mode.
  • Page 15 Each press of the Power button changes the mode and power level. FIG. 9 1. ON/OFF BUTTON 2. GREEN/BLUE INDICATOR LIGHT 3. LOW RF 4. HIGH RF 5. LOW RF AND LOW DMA 6. HIGH RF AND HIGH DMA...
  • Page 16: Before You Begin

    24 hours prior to initial use. To do so, apply a small amount of STOP Preparation Gel to the inner arm and treat the area with the TriPollar STOP V device. Ensure that the skin does not have a negative reaction to the gel or treatment.
  • Page 17: Treating Your Skin

    TREATING YOUR SKIN To treat your skin using the TriPollar STOP V device: 1. Cleanse and dry the treatment area. 2. Apply a very thin, even layer of STOP Preparation Gel over the entire treatment area (face and/or neck). This gel must be used during the entire treatment session.
  • Page 18 5. Divide the entire treatment area into two main sections - one for each side of your face and/or neck (right side and left side). Typically, you treat one side of your face/neck entirely before treating the other side. Divide each side into several working sections that are approximately twice the size of the device head.
  • Page 19 8. Once the orange light turns ON and a beep sounds, continue moving the device within one working section using the same slow circular motions for a few moments and then move to an adjacent working section. The new working section now includes the heated section and the new section, thus enlarging the area.
  • Page 20 For effective treatment, the goal is to maintain the optimal temperature for several seconds before moving to the next treatment section. This means that the orange indicator light should be illuminated as much as possible when treating an area. Important: The orange indicator light turns ON and OFF, depending on the temperature of the skin in the current area of treatment.
  • Page 21 You can apply a moisturizer if you like. 18. Clean the electrodes of the device with a damp cloth or paper towel and cover the device tip with its protective cover. Warning: Do not submerge the TriPollar STOP V device under water.
  • Page 22: Recommended Treatment Guidelines

    • Treating the face with DMA takes approximately 10 minutes. • For optimal results, use the TriPollar STOP V device 2-3 times a week for a period of 6-8 weeks. • Make sure that you allow at least one day in between treatments on the same treatment area.
  • Page 23: Troubleshooting

    This chapter provides customer support contact information for the TriPollar STOP V device. For service, refer to the store where you purchased the TriPollar STOP V device or visit our website at www.stop-age.com. When contacting a local service center, have the device serial number ready. The serial number is located on the top panel of the device.
  • Page 24: Technical Specifications

    TECHNICAL SPECIFICATIONS This chapter presents the specifications for the TriPollar STOP V system. TABLE 1 Technical Specifications Weight: 85gr Physical Dimensions: H=146mm L=50mm W=40mm TriPollar RF Frequency: 1MHz TABLE 2 Operating conditions Temperature: +5°C to +30°C Humidity: 20RH to 80RH Rating: AC 100Vac to 240Vac 0.6 A 50/60Hz...
  • Page 25: Appendix

    HAZARDOUS MATERIALS DECLARATION This appendix provides the hazardous materials declaration for the TriPollar STOP V device. Restriction of Hazardous Substance Material Declaration TABLE 5 - IS IN ACCORDANCE WITH THE PROVISIONS OF SJ/T 11364. Hazardous Substances Part Name PBDE •...
  • Page 26 DESIGN AND TECHNICAL SPECIFICATION ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE. MANUFACTURED AND DISTRIBUTED BY POLLOGEN LTD. PATENTED ISRAELI TECHNOLOGY, MADE IN VIETNAM. THE NAME STOP IS TRADEMARK OF POLLOGEN LTD. THE NAMES POLLOGEN AND TRIPOLLAR ARE REGISTERED TRADEMARKS OF POLLOGEN LTD. FOR MORE INFORMATION, PLEASE VISIT: WWW.STOP-AGE.COM...

Table of Contents

Save PDF