Table of Contents
Advertisement
Oils used to standardize EZ™ Cups are produced and ISO certified
•
Quality Management System, comply with the requirements and
guidance of ISO 17034 and quality control is done from an ISO/IEC
17025 accredited laboratory.
•
The EZ™ Cup formula for each cup of the series matches the applicable
ASTM formula in D4212 at the recommended calibration level.
•
EZ™ Cups are compatible to ASTM D1084 Viscosity of Adhesives and
ASTM D816.
Conversion table relating efflux time in seconds, to the nearest tenth
•
of a second, to viscosity in centistokes furnished with each EZ™ Cup.
•
EZ™ Cup calibration is traceable to the National Institute of Standards
and Technology.
Calibration and Certification procedures qualify under ISO/IEC 17025
•
as applicable.
•
The EZ™ Cup is not matched by any other cup of its type, either with
respect to the advantages listed above, in highest quality of workmanship
or in continuing quality control procedures.
•
All stainless steel cup and handle.
•
THE FINEST, MOST RELIABLE, CALIBRATED & DOCUMENTED
CUP ON THE MARKET!
Additional EZ™ Cup Advantages
•
The EZ™ Cup orifi ces are machined rather than drilled to ensure
exact centering in the cup hemisphere base and a minimum of burr
formation. This ensures an orifi ce of specifi ed length and a correct
symmetrical effl ux stream.
•
The EZ™ Cup support rods are offset from the side of the cup and
secured to the cup sidewall below the cup rim. This eliminates errors
due to test material drainage from support surfaces.
•
The increased separation width of the support rods by over 20% and
the lowering of weld to the cup provide best possible conditions for
cleaning.
DEVELOPED AND MANUFACTURED BY PAUL N. GARDNER (GARDCO
Registered Trademark of Paul N. Gardner
CALIBRATED EZ™ ZAHN (ASTM) DIP
VISCOSITY CUP SERIES
3% GUARANTEED TOLERANCE
COMPLIES WITH & EXCEEDS
Paul N. Gardner • www.gardco.com • (954) 946-9454
ASTM D4212
®
EZ™ is a
)
VISCOSITY
1
Advertisement
Table of Contents
