Directions For Use; Replacing The Uv-C Bulb - Guardian GG1000 Use & Care Instructions Manual

DIRECTIONS FOR USE

1. Plug the unit into a 120V AC electrical outlet.
2. For best results continuous operation is recommended.
NOTE: THE PLUGGABLE UV-C AIR SANITIZER UNIT
CONTAINS NOSERVICEABLE PARTS EXCEPT ITS UV-C
BULB. THE BULB MAY BE REMOVED FOR REPLACEMENT.
1. Unplug the unit from
the electrical outlet.
5. Hold the unit in place
with one hand. Locate
the bulb and reach into
the cylinder.

REPLACING THE UV-C BULB

2. Using a small Phillips
head screwdriver,
loosen and remove the
Phillips screw located
at the top backside of
the unit.
6. With your opposite
hand, turn the bulb in
a counter-clockwise
direction (left) to loosen
from the socket.
WHEN TO CHANGE THE BULB
A replaceable 3.5 watt UV-C light bulb will last approximately 5000 hours.
Over time with use the UV-C bulb will lose some intensity approximately
15% at 4000 hours. Therefore it is suggested to replace the UV-C light
bulb approximately every 6 months (depending on use). You will know to
change the bulb when the light flickers continuously or changes colors.
Replacement bulb no. LB1000.
3. Remove the top cap by
lifting it off of the top of
the unit.
7. Take new bulb and screw into unit using a clockwise motion.
8. Wipe off fingerprints wirh a dry cloth after
9. Reassemble by reversing steps 1-6.
4. Place the unit on a table
or level surface in the
upright position.
E-3