Red Sea MAX S-Series Manual page 122

MAX S-Series LED Installation & Operation Manual's
®
Leveling Aquarium
The spirit level can be placed on the plastic rim that is around the top or bottom of the glass. To raise or lower the
aquarium use the spanner provided to turn the bottom nut on the adjustable feet. The top nut is for locking the
feet in position once the leveling is complete.
To level the aquarium start by adjusting the forward/ backward direction on both sides and only after both sides
are level adjust the left/right alignment by raising or lowering both of the feet on one side.
When both directions are level, check that you are satisfied with the distance between the side panels and the
floor. If necessary raise or lower all four corner feet until you achieve the desired distance. When satisfied with
the height and leveling lock the four corner feet in position by raising the upper lock nut until tight against the
steel foot plate.
Now lower each of the other feet until they are properly in contact with the floor (pay special attention when on
carpet) and lock each one in position with the lock nut.
Color Trim
The color trim pack contains a set of plastic parts that are painted to the designated color. Each trim pack has a
corresponding color cabinet pack that includes the cabinet side panels and doors.
The trim pack includes; the upper and lower plinth that is part of the cabinet, the color trim for the upper and
lower rim of the aquarium, the front panels and end caps for the lighting unit.
The color trim for the upper and lower rim of the aquarium and the front panel are fitted by sliding them on to
their corresponding part on the aquarium or light. In the event that the trim does not slide smoothly carefully
push the trim into position by tapping the end with the rubber mallet.
Cable identification labels
Before installing lights, pumps, skimmer or additional equipment on the aquarium place the identifier labels on
the cables near to the plug. The icons on the cable labels correspond to the icons for the switches and outlets of
the power center.
Skimmer
Chiller
Accessory 1
Accessory 2
Heater
8
Main Pump
Circulation Pump 1
Circulation Pump 2
Circulation Pump 3
Circulation Pump 4
Installation & Operation Manual