6: Adjusting The Speaker Levels And Balance; Test Tone - Sony STR-DE598 Operating Instructions Manual

Tip
Surround speaker position is designed specifically for
implementation of the Cinema Studio EX modes.
For other sound fields, speaker position is not so
critical. Those sound fields were designed under the
premise that the surround speakers would be located
behind the listening position, but presentation remains
fairly consistent even with the surround speakers
positioned at a rather wide angle. However, if the
speakers are pointing toward the listener from the
immediate left and right of the listening position, the
surround effects becomes unclear unless set to
"SIDE/LO" or "SIDE/HI".
Nevertheless, each listening environment has many
variables, such as wall reflections, and you may obtain
better results using "BEHD/HI" if your speakers are
located high above the listening position, even if they
are to the immediate left and right.
Therefore, although it may result in a setting contrary
to the above explanation, we recommend that you
playback multi channel surround encoded software and
select the setting that provides a good sense of
spaciousness and that best succeeds in forming a
cohesive space between the surround sound from the
surround speakers and the sound of the front speakers.
If you are not sure which sounds best, select
"BEHD/LO" or "BEHD/HI" and then use the speaker
distance parameter and speaker level adjustments to
obtain proper balance.
x SP > XXX Hz
(Speaker crossover frequency)*
Initial setting: 100 Hz
Lets you adjust the bass crossover frequency of
speakers in SET UP menu. You can adjust the bass
crossover frequency from 40 Hz to 160 Hz in 9 steps.
* This setup item is only available when at least one
speaker is set to "SMALL" and the corresponding
speaker segment flashes in the display.
6: Adjusting the speaker
levels and balance

— TEST TONE

Adjust the speaker levels and balance while
listening to the test tone from your listening
position. Use the remote for the operation.
Tip
The receiver employs a test tone with a frequency
centered at 800 Hz.
1
Press ?/1 to turn on the receiver.
2
Press TEST TONE.
"T. TONE" appears in the display and the
test tone is output from each speaker in
sequence.
Front (left) t Center t Front (right) t
Surround (right) t Surround back t
Surround (left) t Sub woofer
3
Adjust the speaker levels and balance
using the LEVEL menu so that the level
of the test tone sounds the same from
each speaker.
For details on the LEVEL menu settings,
see page 37.
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/– on the remote or
turn MASTER VOLUME –/+ on the receiver.
• The adjusted value are shown in the display
during adjustment.
4
Press TEST TONE again after
adjustment.
The test tone turns off.
Notes
• The test tone cannot be used when MULTI CH IN
function is used.
• Although these adjustments can also be made via the
front panel using the LEVEL menu (when the test
tone is output, the receiver switches to the LEVEL
menu automatically), we recommend you follow the
procedure described above and adjust the speaker
levels from your listening position using the remote.
21 GB