Page 2
Related knowledge / Precautions Foreword The batteries will gradually age over time after being made. As the battery electrode plate surface age and produces sulfides, the batteries can not undergo the chemical reactions effectively, this is the main reason the most batteries cannot continue to be used. At this time, the internal resistance of the batteries increases.
Technical parameters About The tester can detect out the battery's voltage(V), cold cranking ampere(CCA), battery life(%), internal resistance(mΩ) and the state of health(%) in 5 seconds, it can also detect out if the battery needs to be charged or damaged. The tester suitable for automotive start system and charging system, convenient and practical.
Part names and functions Introduction Paper cover Prying plate Please pay attention to the side of thermal paper when replace it. Protective sleeve 12/24V PULSE TECH LCD screen Lead-Acid Multi Battery Analyzer and Electrical System Tester BACK Keypad Back / Exit DOWN Up &...
Operations Main menu / System option MAIN MENU The screen will show the voltage of the battery when the analyzer starts. Use UP and DOWN keys to select 12V or 24V according your battery. Then press ENTER to access the MAIN MENU.There are three sub- menus: BATTERY TEST, SYSTEM TEST and SYSTEM OPTION.
Page 6
Operations Battery test BATTERY TEST ●Vehicle's ignition is switched OFF and all electrical equipment is OFF. ●Select BATTERY TEST then press ENTER. ●If the battery voltage is too low, the tester will display a warning, it is recommended to charge the battery to achieve an accurate assessment of the battery condition.
Page 7
Operations Battery test STATE OF HEALTH (BATTERY CONDITION) The result and advice Battery Condition Battery in peak condition SOH > 80% Serviceable / good SOH 60%~80% Poor condition, will need replacement soon SOH 45%~60% Replace battery SOH < 44% If rating standard and range is unknown, please select "?". Testing result will show SOC (state of charge) and internal resistance but no the SOH (state of health) and state.
Operations System test ●Select SYSTEM TEST, press ENTER. ●Following the instruction on the screen, make sure the vehicle's ignition is switched OFF and all electrical equipment is OFF. Press ENTER to continue. ●Following the instruction on the screen, start the engine the tester will start to test automatically.
Maintenance Replace the thermal paper ●To get access to paper roll, lift the prying plate in the middle of the paper cover up from tester. ●Replace the thermal paper. ●Pull out the head of paper and put it under the black rubber roller and close the paper cover back.
Appendix 1: Common Abbreviation Of Batteries B S R(British Standards). Continuous output on average current intensity at 0°F(-18°C), the minimum voltage can be maintained over 6.0 volts for 150 seconds. DIN(German Institute for Standardization). For 100DIN, each 100DIN battery at 0°F(-18°C), the battery needs to carry 100 amperes, and over 8.0 volts for 150 seconds.
Appendix 2: The Conversion Tables Of Battery Size Range EN and DIN Conversion Tables Specification Specification Type Same Type Type Same Type 52815 56322 52805 56420 88066 56618 53517 56530 56638 53521 56619 53520 53522 56618 56620 53638 56647 53625 53836 56633 56641...
Appendix 3: Test report and treatment recommendations Continue to use Continue to use Close to replace, can continue to use Need replace Retest after charge. If you get the "CHARGE & RETEST" conclusion again,replace the battery. If you get one of the four results before, according to the corresponding conclusion.