Summary of Contents for ISE WEST 4400
- Page 1 MODEL 4400 TEMPERATURE CONTROL 10100 Royalton Rd. Cleveland, OH 44133 (440) 237-3200 (440) 237-1744 http://iseinc.com...
- Page 2 ISE can provide additional application specific assistance. We also have other tools available such as the full instrument manuals, configuration software and full SCADA software that are compatible with this control. Visit our web site at http://iseinc.com...
-
Page 3: Run Status Indicators
CONTROL STATUS RUN STATUS INDICATORS INDICATORS RUN: Program running Auto Tune HLD: Program held. ALM: Indicates status alarm output. OP1: indicates status of output #1. X60: When on: min:seconds. OP2: Indicates status of output #2. MAN: Lit if in manual mode. EVENT INDICATORS MODE INDICATORS EV1-EV4:... - Page 4 UP/DOWN ARROWS: Raises/Lowers value of displayed parameter. SCROLL KEY: Displays the next parameter in sequence. Also used to display the program progress in the message display while the program is running. MODE KEY: Cycles between Normal Display, Controller Mode, & Program Modes.
-
Page 5: Control Parameters
1) Press UP ARROW & SCROW KEYS at same time. “Unlock” will be displayed in message display. Use ARROW KEYS to display your Lock Code (ISE Lock Code as shipped is 10). After setting appropriate Lock code press SCROLL KEY then MODE KEY to get into controller parameter mode. - Page 6 1) Press UP ARROW & SCROW KEYS at same time. “Unlock” will be displayed in message display. 2) Use ARROW KEYS to display your lock code (ISE lock code as shipped is 10). 3) After setting appropriate lock code press SCROLL KEY to get into program parameter mode. Press PROG Button until Program number displays “A”.
- Page 7 2) Press UP ARROW & SCROLL KEYS at same time. “Unlock” will be displayed in message display. 3) Use ARROW KEYS to display your lock code (ISE lock code as shipped is 10). 4) After setting appropriate lock code press SCROLL KEY. Use SCROLL KEY to go from parameter to parameter and ARROW KEYS to change values for the parameters.
-
Page 8: General Instructions
GENERAL INSTRUCTIONS TO RUN A PROGRAM Apply power to control. 2. Select desired recipe number with PROG BUTTON. 3. Press RUN/HOLD BUTTON. To Select Manual Control Press “Scroll” & “Mode” keys at same time. (This mode is normally disabled in the control setup) To Activate Self Tune Make sure no programs are running. -
Page 9: To Hold A Program
TO HOLD A PROGRAM Holding a program stops the time from advancing. It holds the setpoint at the current value. To hold the program press and release the RUN/HOLD button. HLD light will illuminate. To continue with program press and release RUN/HOLD button again. HLD light will go out. TO ABORT A PROGRAM Aborting a program stops the program permanently. - Page 10 Parameter List Your Parameter Name Value ISE Default Units Control Setpoint While Not Running a Program (page 5) Setpoint * Degrees Control Parameters (page Filter 2 Seconds Offset 0 Degrees Out1 Read Only % Out2 Read Only % P.Band1 5.0 % P.Band2...
- Page 11 Program Parameters (Profile) page 7 Final Setpoint 1 Degrees Time Rate 1 Hrs.Min Event Outputs 1 Binary Value Final Setpoint 2 Degrees Time Rate 2 Hrs.Min Event Outputs 2 Binary Value Final Setpoint 3 Degrees Time Rate 3 Hrs.Min Event Outputs 3 Binary Value Final Setpoint 4 Degrees...
Need help?
Do you have a question about the WEST 4400 and is the answer not in the manual?
Questions and answers