Anolis ArcLine Mini Outdoor 9 User Instructions

The product generates colored light by means of high power LEDs.The product was designed for interior and
exterior use and it is ideal for locations where signaling,directional or effect lighting is required.
1.Attention
Consider the respective national norms during the installation!
Do not install the unit near naked flames.
Avoid using the unit in locations subject to possible impacts.
Do not attempt to dismantle or modify the unit.
Do not install the module in badly ventilated location
Avoid looking directly into the LED light beam at close range.
2.Installation
The ArcLine Mini Outdoor unit should be connected to the ArcPower 36/72/144/360 or the ArcPower 384 Rack
mount (set at 350mA). See their user manuals for full details of mains power requirements and DMX operation.
For fastening the ArcLine Mini on the wall (flat surface etc) are intended two L-brackets with mountings holes
of diameter of 5 mm each. Adjusting screws on both sides of the ArcLine Mini unit allow to set desired position
in tilt movement.
The ArcLine Mini Outdoor unit can be arranged in any position orientation.
Only one LED module can be connected to the LED output of the ArcPower driver.
If you need to connect more than one LED module to the ArcPower driver, you have to use the ArcLine Mini
Outdoor IN/OUT version. The last LED module has to be this standard ArcLine Mini Outdoor - see the ArcLine
Mini Outdoor IN/OUT user manual. Do not overload LED output of the ArcPower driver.
3.Connections
1. ArcLine Mini Outdoor
User instructions
ArcLine Mini Outdoor 9/12/18/27/36
1