Advertisement
Instruction Manual
SANZUCO Digital Wireless Intercom FTAN40A
Features of FTAN40A
● TALK/CALL function （One-to-One ）
Communication between rooms in your home or office.
● GROUP function （One-to-Multi）
Communication for calling family or office, delivering annonouncements
or emergency calls.
● Baby /Elderly Monitor Function
● VOX Function
● Alert Function
Advertisement
Table of Contents
Summary of Contents for SANZUCO FTAN40A
- Page 1 Instruction Manual SANZUCO Digital Wireless Intercom FTAN40A Features of FTAN40A ● TALK/CALL function （One-to-One ） Communication between rooms in your home or office. ● GROUP function （One-to-Multi） Communication for calling family or office, delivering annonouncements or emergency calls. ● Baby /Elderly Monitor Function ●...
- Page 2 Intercom Controls ABC Code Switch Mirco USB 5V USB cable Adaptor...
-
Page 3: Talk Group Call
MONITOR TALK GROUP CALL • MONITOR Button: Can be act as a baby / elderly voice monitor; You can easy to know what's going on with your family member in the other room or house.No time limited. Set monitor room and monitored room at same channel number and press Monitor Button in Monitored room. -
Page 4: Operation
receiver can answer transmitter by TALK within 10 seconds. Set up instruction 1. Power on the device. 2. Digital key will be lighted. If no light please plug in power cable for charge it. After ten minutes then put down power button once again. 3. - Page 5 ● Group Function (one-to-multi ) Press "GROUP" to talk,then you will see the logo turning red ,all other devices can hear you, and the other stations need to press and hold "GROUP" to answer. ● VOX Function 1. The transmit operation can be initiated directly by voice without having to press any button. 2.
-
Page 6: Troubleshooting
●Change the GROUP Number The GROUP number set to “0” as default, Normally you need not change it. If you find that the GROUP number is being used by others or if interference is present. The method to change the GROUP number is as follows: Press and hold the "-"... -
Page 7: Important Precaution
2) The distance of the device with other electrical equipment should be more than 1 meter, in order to avoid interference from the electrical equipment. 3) Do not lay the power cable on the surface of the device. 4) Change to a new channel number. ●... -
Page 8: The Fcc Wants You To Know
CHANNEL NUMBER WITH FREQUENCY Channel Frequency (MHz) 462.6625 467.7125 467.6875 467.6625 467.6375 467.6125 467.5875 467.5625 462.7125 462.6875 THE FCC WANTS YOU TO KNOW Your intercom might cause TV or radio interference even when it is operating properly. To determine whether your intercom is causing the interference, turn off the stations, if the interference goes away, your intercom is causing the interference. - Page 9 The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located for operating in conjunction with any other antenna or transmitter. Important: Do not hold down CALL for more than 10 seconds. The FCC does not allow you to send a continuous tone for more than 10 seconds at a time on FRS frequencies.
- Page 10 (11) Programs (live or delayed) intended for radio or television station broadcast; (12) Messages which are both conveyed by a wire line control link and transmitted by a GMRS station; (13) Messages (except emergency messages) to any station in the Amateur Radio Service, to any unauthorized station, or to any foreign station;...
Need help?
Do you have a question about the FTAN40A and is the answer not in the manual?
Questions and answers